User manual EINHELL BG-PW 48

[. . . ] The machine must not be used to transport inflammable, gassing, explosive and aggressive fluids (such as petrol, acids, lyes, silo percolating juice, etc. ) and fluids that contain abrasive substances (such as sand). The machine is to be used only for its prescribed purpose. Any other use is deemed to be a case of misuse. [. . . ] Misfires, start-up difficulties: Check whether fuel is flowing into the carburetor; the fuel filter is clean; the carburetor air valve is open; the air filter is clean; the spark plug is clean and the electrode gap is between 0. 2 Maintenance In this connection, please also read the attached service information 7. 1 Changing the oil The engine oil is best changed when the engine is at working temperature Use only engine oil (10W40). Place the machine on a slightly inclined surface so that the oil drain plug is at the lower end (Figure 5a / Item A). Remove the oil filler screw (Figure 5a / Item B). Remove the oil drain plug and drain the warm engine oil into a suitable container. After all the oil has drained, screw in the oil drain plug and place the machine on a flat surface. Insert fresh engine oil up to the top mark on the oil dipstick (Figure 5b / Item H). Only inset the oil dipstick to check the oil level. While the machine is working, the oil level must be between the two marks "L" and "H" (Figure 5b). Remove the screw from the air filter cover (Figure 6a) Remove the air filter cover. remove the screw from the air filter element (Figure 6b) Remove the air filter element (Figure 6c). Clean the air filter by tapping it, blowing it out with compressed air or by washing it with soap suds. Leave the air filter to dry before you refit it. Remove the spark plug boot by twisting it (Figure 7) Remove the spark plug using a spark plug wrench Clean the spark plug with a copper wire brush or fit a new one. Disconnect the spark plug boot before doing any cleaning and maintenance work!1 Cleaning Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe the equipment with a clean cloth or blow it with compressed air at low pressure. We recommend that you clean the device immediately each time you have finished using it. Clean the equipment regularly with a moist cloth and some soft soap. Do not use cleaning agents or solvents; these could attack the plastic parts of the equipment. Ensure that no water can seep into the device. [. . . ] Guarantee claims should be submitted before the end of the guarantee period within two weeks of the defect being noticed. no guarantee claims will be accepted after the end of the guarantee period. The original guarantee period remains applicable to the device even if repairs are carried out or parts are replaced. In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. [. . . ]