User manual EINHELL BG-WW 1355 NN

[. . . ] The operator is responsible for complying with local safety and installation regulations. (Ask an electrician if you are in any doubt. ) Consequential damage caused by flooded rooms in the event of the equipment suffering faults must be prevented by the user by means of suitable measures (for example installing alarm systems or a reserve pump, etc. In the event of a failure, repair work may only be carried out by an electrician or by ISC after sales service personnel. [. . . ] Avoid positioning the suction pipe higher than the pump, as this would delay the escape of air bubbles from the suction pipe and impede the priming process. Install the intake and discharge lines in such a way that they do not exert any mechanical pressure on the equipment. The intake valve should be low enough in the water to ensure that if the water level falls, the equipment will not run dry. A leaking intake line will draw in air and therefore not draw in any water. 2 Connecting the discharge line The discharge line (min. 3/4") must be connected to the 1" female thread discharge line connector of the equipment either directly or with the aid of a threaded nipple. With the right couplings it is also possible, of course, to use a 1/2" delivery hose. the smaller delivery hose results in a lower delivery rate. During the priming operation, fully open any shut-off mechanisms (spray nozzles, valves, etc. ) in the pressure line so that the air can escape without obstruction. The pump is switched off automatically by the thermostat if overheating occurs and is switched on again automatically after cooling. Fill the pump housing with water via the water filler screw (5). The intake process starts automatically; water can be suctioned in for up to 5 minutes (maximum suction height). The equipment will shut down when the cut-out pressure of 3 bar is reached. After a loss of pressure due to water consumption the equipment will cut in again automatically (cut-in pressure approx. Important: Be sure to completely empty the water bag first using the water drain screw (2). Replacing the mains cable: Important: Disconnect the equipment from the power supply! a defective mains cable may only be replaced by a qualified electrician. There are no parts inside the equipment which require additional maintenance. 2 Storage If the pump is not going to be used for a long time or has to be removed for the winter months, rinse it out with water, empty it completely and allow it to dry. The equipment must be completely drained before it is subjected to frost. After long stoppages, make sure the rotor turns correctly by briefly switching the pump on and off. [. . . ] Consequently, the guarantee is invalidated if the equipment is used in commercial, trade or industrial applications or for other equivalent activities. The following are also excluded from our guarantee: compensation for transport damage, damage caused by failure to comply with the installation/assembly instructions or damage caused by unprofessional installation, failure to comply with the operating instructions (e. Connection to the wrong mains voltage or current type), misuse or inappropriate use (such as overloading of the device or use of non-approved tools or accessories), failure to comply with the maintenance and safety regulations, ingress of foreign bodies into the device (e. Damage caused by the device being dropped) and normal wear resulting from proper operation of the device. [. . . ]