User manual EINHELL BT-AC 140-24 OF

[. . . ] Intake air filter Pressure vessel Wheel Supporting foot Quick-lock coupling (regulated compressed air) Pressure gauge (for reading the preset tank pressure) Pressure gauge (for reading the tank pressure) Pressure regulator Pressure switch ON/OFF switch Transportation handle Safety valve Non-return valve Drainage screw for condensation water Report any damage immediately to the company which delivered the compressor. The compressor should be set up near the working consumer. Avoid long air lines and long supply lines (extensions). Make sure the intake air is dry and dust-free. [. . . ] Safety information for paint spraying Never process paints or solvents with a flash point below 55°C. It is imperative to use filtering equipment (face masks) when processing harmful liquids. Note also the information concerning safety precautions published by the manufacturers of these liquids. Smoking is prohibited during the spraying operation and in the work room. Make sure there are no open fires or open lights in the work room. Do not keep or consume food and drink in the work room. The details and designations of the Ordinance on Hazardous Substances, which are displayed on the outer packaging of the processed material, must be observed. Additional protective measures are to be undertaken if necessary, particularly the wearing of suitable clothing and The work room has to be bigger than 30 m3 and have sufficient ventilation for spraying and drying. It is always imperative to observe the regulations of your local police authorities when spraying combustible or hazardous substances. Never process media such as white petroleum spirit, butyl alcohol and methylene chloride with the PVC pressure hose (reduced life span). 4 Operating pressure vessels An operator of a pressure vessel is required to keep the pressure vessel in good working order, to operate it properly, to supervise its use, to carry out essential maintenance and repair work immediately, and to introduce essential safety measures according to requirements. The supervisory authorities may order essential safeguards from case to case. A pressure vessel may not be operated if it has any defects which constitute a danger to employees or third parties. The pressure vessel must be regularly inspected for damage, e. If you discover any damage, then please contact the customer service workshop. Keep these safety instructions in a safe place. 3) You can adjust the pressure on the pressure gauge (6) using the pressure regulator (8). The set pressure can be taken from the quicklock coupling (5). The tank pressure can be read on the pressure gauge (7). 6 Setting the pressure switch (3) The pressure switch is set at the factory. Switch-on pressure 6 bar Switch-off pressure 8 bar Power supply: Motor rating in kW/HP: Compressor speed in rpm: Operating pressure in bar: Pressure vessel volume in litre: Theoretical intake rate in l/min. : Sound power level LWA in dB: Sound pressure level LpA in dB: Protection type: Machine weight in kg: 230 ~ 50 Hz 1. [. . . ] Defective components must be disposed of as special waste. Make sure that the extension cable is not too long. Use an extension cable with large enough wires. Never operate with an outside temperature of below +5°C. [. . . ]