User manual EINHELL BT-AC 200-24 OF

[. . . ] When using equipment, a few safety precautions must be observed to avoid injuries and damage. Please read the complete operating manual with due care. Keep this manual in a safe place, so that the information is available at all times. If you give the equipment to any other person, give them these operating instructions as well. [. . . ] The pressure vessel must be regularly inspected for damage, e. If you discover any damage, then please contact the customer service workshop. Keep these safety instructions in a safe place. Housing cover Pressure vessel Wheel Supporting foot Quick-lock coupling (regulated compressed air) Pressure gauge (for reading the preset tank pressure) Pressure regulator ON/OFF switch Transportation handle Safety valve Drainage screw for condensation water Please note that our equipment has not been designed for use in commercial, trade or industrial applications. Our warranty will be voided if the machine is used in commercial, trade or industrial businesses or for equivalent purposes. The machine is to be used only for its prescribed purpose. Any other use is deemed to be a case of misuse. The user / operator and not the manufacturer will be liable for any damage or injuries of any kind caused as a result of this. Power supply: Motor rating in kW/HP: Operating mode Compressor speed in rpm: Operating pressure in bar: Pressure vessel volume in litre: Theoretical intake rate in l/min. : Sound power level LWA in dB: Sound pressure level LpA in dB: Protection type: Machine weight in kg: 230 ~ 50 Hz 1. 3 Voltage The compressor is equipped with a mains cable with shock-proof plug. This can be connected to any 230V ~ 50Hz shock-proof socket which is protected by a 16 A fuse. Before you use the machine, make sure that the mains voltage complies with the specifications on the rating plate. In the case of low temperatures below +5°C, motor start-up is jeopardized as a result of stiffness. Move the On/Off switch (8) to position 0 to switch off the equipment. 1) You can adjust the pressure on the pressure gauge (6) using the pressure regulator (7). The set pressure can be taken from the quicklock coupling (5). 6 Setting the pressure switch The pressure switch is set at the factory. Switch-on pressure 6 bar Switch-off pressure 8 bar You must fully assemble the appliance before using it for the first time. Operating mode S3 - 25% - 10min: S3 = Intermittent mode without influencing the starting process. This means that during a period of 10 min the max. Report any damage immediately to the company which delivered the compressor. [. . . ] Use an extension cable with large enough wires. Never operate with an outside temperature of below +5°C. Check the seals and have any damaged seals replaced by a service center 3. The compressor starts but there is no pressure The compressor starts, pressure is 1. [. . . ]