User manual EINHELL BT-AG 2000

[. . . ] We accept no liability for damage or accidents which arise due to non-observance of these instructions and the safety information. 4. Technical data Mains voltage: Power input: Idling speed: Max. wheel diameter: Mounting spindle thread: Protection class: LpA sound pressure level: LWA sound power level: Vibration ahv: Weight: 230 V ~ 50 Hz 2000 W 6, 000 rpm 230 mm M14 II / ® 95 dB 106 dB 15. 010 m/s2 5. 0 kg 1. Safety information Please refer to the booklet included in delivery for the safety instructions. [. . . ] You can then position the angle grinder on the workpiece and machine it. 5) Use the face spanner (6) supplied to change the grinding wheels. Simple wheel change by spindle lock: Press the spindle lock and allow the grinding wheel to latch in place. Open the flange nut with the face spanner. 5) Change the grinding or cutting wheel and tighten the flange nut with the face spanner. Only ever press the spindle lock when the motor and grinding spindle are at a standstill!You must keep the spindle lock pressed while you change the wheel!For grinding or cutting wheels up to approx. 3 mm thick, screw on the flange nut with the flat side facing the grinding or cutting wheel. 6. 3 Flange arrangements when using grinding wheels and cutting wheels (Fig. 6-9) Flange arrangement when using a depressedcentre or straight grinding wheel (Fig. 7) a) Clamping flange b) Flange nut Flange arrangement when using a depressedcentre cutting wheel (Fig. 8) a) Clamping flange b) Flange nut Flange arrangement when using a straight 10 7. Replacing the power cable If the power cable for this equipment is damaged, it must be replaced by the manufacturer or its aftersales service or similarly trained personnel to avoid danger. Anleitung_BT_AG_2000_SPK1:_ 26. 02. 2008 14:07 Uhr Seite 11 GB 8. Cleaning, maintenance and ordering of spare parts Always pull out the mains power plug before starting any cleaning work. 8. 1 Cleaning Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe the equipment with a clean cloth or blow it with compressed air at low pressure. We recommend that you clean the device immediately each time you have finished using it. Clean the equipment regularly with a moist cloth and some soft soap. Do not use cleaning agents or solvents; these could attack the plastic parts of the equipment. Ensure that no water can seep into the device. 8. 2 Carbon brushes In case of excessive sparking, have the carbon brushes checked only by a qualified electrician. [. . . ] In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. This also applies when an on-site service is used. In order to assert your guarantee claim, please send your defective device postage-free to the address shown below. Please enclose either the original or a copy of your sales receipt or another dated proof of purchase. [. . . ]