User manual EINHELL BT-AG 850

[. . . ] We accept no liability for damage or accidents which arise due to non-observance of these instructions and the safety information. 4. Technical data Mains voltage: Power input: Idling speed: Max. wheel diameter: Mounting spindle thread: Protection class: Weight: 230 V ~ 50 Hz 850 W 11000 rpm 115 mm M14 II / ® 1. 7 kg 1. Safety information Please refer to the booklet included in delivery for the safety instructions. [. . . ] 6. 6 OPERATING MODES 6. 6. 1 Rough grinding For the best rough grinding results, hold the grinding wheel at an angle of between 30° and 40° to the workpiece surface and guide back and forth over the workpiece in steady movements. 5. 2 Setting the guard (Fig. Adjust the guard (4) to protect your hands so that the material being ground is directed away from your body. The position of the guard (4) can be adjusted to any specific working conditions. Undo the screw (a) and turn the cover (4) into the required position. Ensure that the guard (4) correctly covers the gear wheel casing. Never use the angle grinder without the guard. 5. 3 TEST RUN FOR NEW GRINDING WHEELS Allow the right-angle grinder to run in idle for at least 1 minute with the grinding or cutting wheel fitted in place. Vibrating wheels are to be replaced immediately. 6. 4) The angle grinder comes with a safety switch which is designed to prevent accidents. To switch on, push the slide switch (a) to the right while at the same time pushing the ON/OFF switch (2) forwards and depressing. To switch off the angle grinder, depress the button (2) at the back. The switch (2) will jump back into its starting position. Wait until the machine has reached its top speed. You can then position the angle grinder on the workpiece and machine it. 5) Use the face spanner (5) supplied to change the grinding wheels. Simple wheel change by spindle lock: Press the spindle lock and allow the grinding wheel to latch in place. 6 Anleitung_BT_AG_850_SPK7:_ 03. 09. 2008 13:03 Uhr Seite 7 GB 6. 6. 2 Cutting When you use the right-angle grinder for cutting purposes, avoid tilting it in the cutting plane. The cutting wheel must have a clean cutting edge. A diamond cutting wheel is best used to cut hard stone. It is prohibited to use the machine on asbestos materials!Never use a cutting wheel for rough grinding. 8. 4 Ordering replacement parts Please quote the following data when ordering replacement parts: Type of machine Article number of the machine Identification number of the machine Replacement part number of the part required For our latest prices and information please go to www. isc-gmbh. info 9. [. . . ] In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. This also applies when an on-site service is used. In order to assert your guarantee claim, please send your defective device postage-free to the address shown below. Please enclose either the original or a copy of your sales receipt or another dated proof of purchase. [. . . ]