User manual EINHELL BT-AP 600 E

[. . . ] We accept no liability for damage or accidents which arise due to non-observance of these instructions and the safety information. businesses or for equivalent purposes. 4. Technical data Mains voltage: Power: Stroke rate: Stroke height: Cutting depth in wood: Cutting depth in iron: Protection class: Weight: 230 V~ 50 Hz 650 W 500-3000 min-1 20 mm 115 mm 10 mm II / 2. 82 kg 1. Safety regulations The corresponding safety information can be found in the enclosed booklet. [. . . ] The general rules for cutting speeds for cutting work apply. 4) Place the multi-saw on the material to be cut as shown in Fig. Switch on the multi-saw and push it along against the material to be cut. Adapt your cutting speed to the material. 7. Replacing the power cable If the power cable for this equipment is damaged, it must be replaced by the manufacturer or its aftersales service or similarly trained personnel to avoid danger. 8. Cleaning, maintenance and ordering of spare parts Always pull out the mains power plug before starting any cleaning work. 8. 1 Cleaning Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe the equipment with a clean cloth or blow it with compressed air at low pressure. We recommend that you clean the device immediately each time you have finished using it. Clean the equipment regularly with a moist cloth and some soft soap. Do not use cleaning agents or solvents; these could attack the plastic parts of the equipment. Ensure that no water can seep into the device. 8. 2 Carbon brushes In case of excessive sparking, have the carbon brushes checked only by a qualified electrician. The carbon brushes should not be rep laced by anyone but a qualified electrician. 8. 3 Maintenance There are no parts inside the equipment which require additional maintenance. 6. 1/Item 1) To switch on: Press the ON/OFF switch To switch off: Release the ON/OFF switch 6. 2 Locking button (Fig. 1/Item 2) You can lock the ON/OFF switch (1) using the locking button (2) when the equipment is in operation. To switch off the equipment briefly hold down the ON/OFF switch (1). 9 Anleitung_BT_AP_600_E_SPK1:_ 06. 02. 2008 12:52 Uhr Seite 10 GB 8. 4 Ordering replacement parts: Please quote the following data when ordering replacement parts: Type of machine Article number of the machine Identification number of the machine Replacement part number of the part required For our latest prices and information please go to www. isc-gmbh. info 9. Disposal and recycling The unit is supplied in packaging to prevent its being damaged in transit. This packaging is raw material and can therefore be reused or can be returned to the raw material system. The unit and its accessories are made of various types of material, such as metal and plastic. Defective components must be disposed of as special waste. [. . . ] In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. This also applies when an on-site service is used. In order to assert your guarantee claim, please send your defective device postage-free to the address shown below. Please enclose either the original or a copy of your sales receipt or another dated proof of purchase. [. . . ]