User manual EINHELL BT-CD 18 I

[. . . ] If you give the equipment to any other person, give them these operating instructions as well. We accept no liability for damage or accidents which arise due to non-observance of these instructions and the safety information. machine is used in commercial, trade or industrial businesses or for equivalent purposes. 4. Technical data Voltage supply Idling speed: Torque settings: Forward and reverse rotation Chuck clamping width Battery charging voltage Battery charging current Mains voltage for charger Charging time: Battery type: Weight 18 V d. c. [. . . ] Always check for concealed electric cables and gas and water pipes when drilling and screwing in walls. 6. Operation 6. 1 Charging the LI battery pack (Fig. Take the rechargeable battery pack out of the handle (Fig. 2), pressing the pushlock buttons at the side to do so. Check that your mains voltage is the same as that marked on the rating plate of the battery charger. Insert the battery pack in the battery charger. The red LED will come on to indicate that the battery pack is being charged. The green LED will come on to indicate that charging has been completed. The temperature of the battery pack may rise slightly during the charging operation. If the battery pack fails to become charged, please check whether there is voltage at the socket-outlet whether there is proper contact at the charging contacts on the charger. If the battery still fails to become charged, please return the charger the battery pack to our Customer Service Department. To ensure that the battery pack provides long service, you should take care to recharge it promptly. You must recharge the battery pack when you notice that the power of the cordless screwdriver drops. Anleitung_BT_CD_18_i_SPK7:_ 10. 04. 2008 10:49 Uhr Seite 8 GB gears when the tool has stopped. Set the changeover switch (3) to its centre position whenever you carry out any work (for example changing the tool, maintenance work, etc. ) on the cordless screwdriver. The cordless screwdriver is fitted with a quickaction chuck (2) with an automatic spindle stop. The chuck opening (a) must be large enough to hold the tool (drill bit or screwdriver bit). Push the tool as far as possible into the chuck opening (a). Tighten the chuck (2) and then check that the tool is secure. 6. 8 Screwdriving We recommend using self-centering screws (e. g. Torx screws, recessed head screws) designed for reliable working. Be sure to use a bit that matches the screw in shape and size. Set the torque, as described elsewhere in these operating instructions, to suit the size of screw. [. . . ] In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. This also applies when an on-site service is used. In order to assert your guarantee claim, please send your defective device postage-free to the address shown below. Please enclose either the original or a copy of your sales receipt or another dated proof of purchase. [. . . ]