User manual EINHELL BT-HA 2000

[. . . ] Be sure that the openings for air entry and exit are always clean and free of dirt. Hazardous or poisonous gasses can be freed when removing paint. Be sure to provide adequate ventilation while working indoors. Never point the hot air directly at windows or other glass surfaces. [. . . ] glass panes from overheating by diverting the hot air. The wide nozzle (5) provides uniform air distribution on small surfaces The reducer nozzle (6) provides a targeted jet of heat for corners and for soldering work. The reflector nozzle (7) is designed for soldering and shaping tubes, for defrosting water pipes and for shrinking insulating hoses. 4. Technical data Mains voltage: Power input: Temperature: Air volume: Protection class: Weight: 230 V~ 50 Hz 2000 W 350°C / Setting 1 550°C / Setting 2 300 l / Setting 1 500 l / Setting 2 II / 0. 7 kg 5. Before starting the equipment Before you connect the equipment to the mains supply make sure that the data on the rating plate are identical to the mains data. 7. Replacing the power cable If the power cable for this equipment is damaged, it must be replaced by the manufacturer or its aftersales service or similarly trained personnel to avoid danger. 6. Starting up 6. 1 3-setting ON/OFF switch (Figure 3) Select the required working temperature and air volume with the ON/OFF switch (2). Within a very short space of time the hot air gun will reach operating temperature. Setting ­ 350°C / 300 liters/min. Center position: Equipment is switched off. Setting ­ 550°C / 500 liters/min. 6. 2 Possible uses for the hot air pistol: Removal of paint and lacquer. Hazardous or poisonous gasses may be produced while removing paint or lacquer. Be sure to provide adequate ventilation. Loosening of rusted or tightly fastened nuts and metal screws. 8. Cleaning, maintenance and ordering of spare parts Always pull out the mains power plug before starting any cleaning work. 8. 1 Cleaning Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe the equipment with a clean cloth or blow it with compressed air at low pressure. We recommend that you clean the device immediately each time you have finished using it. Clean the equipment regularly with a moist cloth and some soft soap. Do not use cleaning agents or solvents; these could attack the plastic parts of the equipment. Ensure that no water can seep into the device. 9 Anleitung_BT_HA_2000_SPK1:_ 15. 02. 2008 8:51 Uhr Seite 10 GB 8. 2 Maintenance There are no parts inside the equipment which require additional maintenance. [. . . ] In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. This also applies when an on-site service is used. In order to assert your guarantee claim, please send your defective device postage-free to the address shown below. Please enclose either the original or a copy of your sales receipt or another dated proof of purchase. [. . . ]