User manual EINHELL BT-ID 710 E

[. . . ] Read all safety regulations and instructions. Any errors made in following the safety regulations and instructions may result in an electric shock, fire and/or serious injury. Keep all safety regulations and instructions in a safe place for future use. Sound and vibration values were measured in accordance with EN 60745. [. . . ] Select the speed by applying a greater or lesser pressure to the ON/OFF switch (5). Select the correct speed: The most suitable speed depends on the workpiece, the type of use and the drill bit used. Low pressure on the ON/OFF switch (5): Lower speed (suitable for: small screws and soft materials) Greater pressure on the ON/OFF switch (5): Higher speed (suitable for large/long screws and hard materials) Tip: Start drilling holes at low speed. Benefits: The drill bit is easier to control when starting the hole and will not slide away. You avoid drilling messy holes (for example in tiles). 6/Item 6) The speed setting ring (6) enables you to define the maximum speed. The ON/OFF switch (5) can only be pressed to the defined maximum speed setting. set the speed using the setting ring (6) on the ON/OFF switch (5). Do not attempt to make this setting whilst the drill is in use. 4 Starting holes If you wish to drill a deep hole in a hard material (such as steel), we recommend that you start the hole with a smaller drill bit. Switch the drill / hammer drill selector switch (3) to position B (hammer drill) as soon as the drill bit has passed through the tiles. If the power cable for this equipment is damaged, it must be replaced by the manufacturer or its aftersales service or similarly trained personnel to avoid danger. 6 Tips for working with your hammer drill 6. Always use carbide drill bits and a high speed setting for drilling into masonry and concrete. Always use HSS drill bits (HSS = high speed steel) and a low speed setting for drilling steel. We recommend that you lubricate the hole with a suitable cutting fluid to prevent unnecessary drill bit wear. Always pull out the mains power plug before starting any cleaning work. 1 Cleaning Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe the equipment with a clean cloth or blow it with compressed air at low pressure. We recommend that you clean the device immediately each time you have finished using it. Clean the equipment regularly with a moist cloth and some soft soap. Do not use cleaning agents or solvents; these could attack the plastic parts of the equipment. [. . . ] In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. This also applies when an on-site service is used. In order to assert your guarantee claim, please send your defective device postage-free to the address shown below. Please enclose either the original or a copy of your sales receipt or another dated proof of purchase. [. . . ]