User manual EINHELL RG-GP 1355 NM

[. . . ] The operator is responsible for complying with local safety and installation regulations. (Ask an electrician if you are in any doubt. ) Consequential damage caused by flooded rooms in the event of the equipment suffering faults must be prevented by the user by means of suitable measures (for example installing alarm systems or a reserve pump, etc. In the event of a failure, repair work may only be carried out by an electrician or by ISC after sales service personnel. [. . . ] Install the intake and discharge lines in such a way that they do not exert any mechanical pressure on the equipment. The intake valve should be low enough in the water to ensure that if the water level falls, the equipment will not run dry. A leaking intake line will draw in air and therefore not draw in any water. If necessary, install a prefilter for this purpose. 2 Connecting the discharge line The discharge line (min. 3/4") must be connected to the 1" female thread discharge line connector of the equipment either directly or with the aid of a threaded nipple. With the right couplings it is also possible, of course, to use a 1/2" delivery hose. the smaller delivery hose results in a lower delivery rate. During the priming operation, fully open any shut-off mechanisms (spray nozzles, valves, etc. ) in the pressure line so that the air can escape without obstruction. The pump is switched off automatically by the thermostat if overheating occurs and is switched on again automatically after cooling. 2) The garden pump is equipped with a pull-out transport handle (9) and wheels (6) to make it easier to transport. pull out the pull-out transport handle (9) as far as it will go. The pump can now be pulled along with ease. After transport, push the pull-out transport handle (9) back in again. The pump can also be carried by the carry handle (10). Important: Disconnect the equipment from the power supply! a defective mains cable may only be replaced by a qualified electrician. There are no parts inside the equipment which require additional maintenance. 2 Storage If the pump is not going to be used for a long time or has to be removed for the winter months, rinse it out with water, empty it completely and allow it to dry. The equipment must be completely drained before it is subjected to frost. After long stoppages, make sure the rotor turns correctly by briefly switching the pump on and off. [. . . ] Connection to the wrong mains voltage or current type), misuse or inappropriate use (such as overloading of the device or use of non-approved tools or accessories), failure to comply with the maintenance and safety regulations, ingress of foreign bodies into the device (e. Damage caused by the device being dropped) and normal wear resulting from proper operation of the device. The guarantee is rendered null and void if any attempt is made to tamper with the device. The guarantee is valid for a period of 2 years starting from the purchase date of the device. [. . . ]