User manual EINHELL RLH 2500

[. . . ] The corresponding safety information can be found in the enclosed booklet. Fit the chassis to the housing using the two lock nuts (item 2). Use the assembly tool provided for this purpose. Fit the axle (item 3) to the chassis using the two M6 x 50 screws (item 4) and nuts (item 2). [. . . ] To ensure the best possible results from your shredder, the gap between the counter blade (item B) and the shredding blade (item A) should be approx. There is an adjustment device on the right-hand side of the plastic housing for this purpose. Turn the knob clockwise so that the screw (item C) moves towards the shredding blade. After a half-turn the counter blade will have moved 0. After completing this adjustment check whether the blade produces the desired results. IMPORTANT: If the shredding blade touches the counter blade, it will cut it and small metal chips may fall out of the discharge opening. This is not a fault, but it must only be adjusted as much as necessary since otherwise the counter blade will suffer premature wear. Once the blockage has been cleared, return the switch for selecting the direction of rotation to position "1". Power failure Check the mains lead, plug and fuse. Feed in thick branches again so that the blade does not immediately engage again in the notches it previously cut. the shredding blade is jammed Move the switch for selecting the direction of rotation to position "0" and switch on the shredder. The blade will now rotate in the opposite direction and release the jammed material. Do not change the direction of rotation until the shredder has reached a complete standstill. Plastic parts are coded for purposes of separation when recycling. This will help to keep the machine in good working order and is the basis for a long working life. Keep the vent slots clean while you work. Clean the plastic body and other plastic parts with a mild household cleaning agent and a damp cloth. Do not use any aggressive agents or solvents for cleaning purposes. Never clean the shredder by spraying with water. prevent water getting inside the machine at all cost. Check the chassis securing screws from time to time to ensure that they are tight. If you do not intend to use the shredder for a lengthy period, protect it from corrosion using environmentally friendly oil. [. . . ] In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. This also applies when an on-site service is used. In order to assert your guarantee claim, please send your defective device postage-free to the address shown below. Please enclose either the original or a copy of your sales receipt or another dated proof of purchase. [. . . ]