User manual EINHELL RT 350

[. . . ] Failure to observe this instruction will not only create a potential hazard, it will also result in the loss of your rights under the warranty. Never try to stop the cutter (nylon line) with your hands. it is imperative to use only the original nylon line. Never use metal wire instead of the nylon line. [. . . ] Before you connect the grass trimmer to the power supply, make sure that none of its moving parts are damaged and that the line spool is correctly inserted and fastened. Never cut against hard objects when using the grass trimmer. this is imperative to avoid causing injury to the user and damage to the trimmer. Use only original replacement parts for repair and maintenance purposes. have repairs carried out only by a qualified electrician. Examine the grass trimmer for signs of wear or damage each time before you use it and after any collisions. have essential repairs carried out without delay. Always keep your hands and feet away from the cutting mechanism, particularly when you switch on the trimmer. After pulling out new line, always return the trimmer to normal working position before you switch it on again. Never use replacement parts or accessories which are not foreseen or recommended by the manufacturer. Pull out the power plug before carrying out any inspection, cleaning or other work on the trimmer and whenever it is not being used. The nylon line will run on for a few seconds after the tool is switched off!Voltage Power rating Cutting width Speed Nylon cutting line Sound pressure level LPA Sound power level Vibration aw Weight 230V ~ 50 Hz 350 W ø 25 cm 11, 000 rpm ø 1. The noise level of this machine may exceed 85 dB(A). In this case, noise protection measures need to be introduced for the user. The machine's noise was measured in accordance with IEC 59 CO 11, IEC 704, DIN 45635 Part 21, NFS 31-031 (84/538/EEC). This value was determined in compliance with EN 786 Appendix D: 1996+A1: 2001. To install the safety hood Place the safety hood on the motor head (Figure 4) and then turn it clockwise until it engages (Figure 5). The trimmer is designed for cutting lawns and small areas of grass in private and hobby gardens. Tools for private and hobby gardens are not suitable for use in public facilities, parks and sport centers, along roadways, on farms or in the forestry sector. For the tool to be used properly it is imperative to follow the instructions set out in the manufacturer's directions for use. It is prohibited to use the tool to chop material for composting because of the potential danger to persons and property. [. . . ] Never spray down the grass trimmer with water. The machine will not work: Check that the power cable is connected properly and check the mains fuses. If the machine will not work despite the voltage supply being OK, send it to the specified aftersales service address. Important The grass trimmer and its accessories are made of various types of material, such as metal and plastic. [. . . ]