User manual EINHELL RT-HP 1750 TR

[. . . ] Before putting the machine into operation 5. 1 Correctly using the device b The high-pressure cleaner must be set on a level, stable surface. B It is recommended that you maintain the correct operating position every time you use the machine by placing one hand on the pistol and the other on the lance. b Never direct the water jet toward electrical lines or the machine itself. [. . . ] 5 mm2 b Plug the mains plug on the power cable into the mains socket outlet. The equipment consists of an assembly with a pump, which is encased in a shock absorbing housing. The equipment comes with a lance and a non-slip gun (for an optimal working position), whose shape and configuration comply with the applicable regulations. 1 Using for the first time: Once you have completely assembled the highpressure cleaner and connected all connections, proceed as follows: Open the water inlet. 11) on the spray gun and pull back trigger lever "b" (Fig. 11) in order to bleed the trapped air out of the device. To temporarily turn off, release the trigger lever (b), at which point the device goes to standby. As soon as you press the trigger lever again (b), the highpressure cleaner restarts. To completely turn off the high-pressure cleaner, switch the ON/OFF switch (Fig. B Cleaning agent may be used only together with the following accessories. 15) The gun and accessories can be kept in the provided holder (18) in order to save space when not in use. Remedy - Check the fuse, power cable and power plug and have them replaced by qualified personnel if necessary. - Use extension cables with larger cross sections and/or use shorter extension cables. - Contact the power supply company if necessary. - Cross section of the extension cable not large enough and/or the extension cable is too long. The motor starts but there is no build up of pressure - The water intake filter is clogged. K t p erklärt folgende Konformität gemäß EU-Richtlinie und Normen für Artikel declares conformity with the EU Directive and standards marked below for the article déclare la conformité suivante selon la directive CE et les normes concernant l'article verklaart de volgende conformiteit in overeenstemming met de EU-richtlijn en normen voor het artikel declara la siguiente conformidad a tenor de la directiva y normas de la UE para el artículo declara a seguinte conformidade de acordo com a directiva CE e normas para o artigo förklarar följande överensstämmelse enl. T For EU countries only Never place any electric tools in your household refuse. To comply with European Directive 2002/96/EC concerning old electric and electronic equipment and its implementation in national laws, old electric tools have to be separated from other waste and disposed of in an environment-friendly fashion, e. This can also be done by handing over the used device to a returns center, which will dispose of it in accordance with national commercial and industrial waste management legislation. This does not apply to the accessories and auxiliary equipment without any electrical components which are included with the used device. Enligt det europeiska direktivet 2002/96/EG om avfall som utgörs av eller innehåller elektriska eller elektroniska produkter och dess tillämpning i den nationella lagstiftningen, måste förbrukade elverktyg källsorteras och lämnas Återvinnings-alternativ till begäran om återsändning: Som ett alternativ till återsändning är ägaren av elutrustningen skyldig att bidraga till ändamålsenlig avfallshantering för det fall att utrustningen ska skrotas. [. . . ] no guarantee claims will be accepted after the end of the guarantee period. The original guarantee period remains applicable to the device even if repairs are carried out or parts are replaced. In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. This also applies when an on-site service is used. [. . . ]