User manual EINHELL RT-HP 1855 TR

[. . . ] Water inlet pressure: Sound pressure level LpA: Sound power level LWA: Weight: 230 V ~ 50 Hz 2600 W 12 MPa (120 bar) max. The corresponding safety information can be found in the enclosed booklet. Read all safety regulations and instructions. Any errors made in following the safety regulations and instructions may result in an electric shock, fire and/or serious injury. [. . . ] 2) The power cable can be wound up on the cable holder (9) in order to save space when not in use. Remove the high-pressure hose from the pressure cleaner. secure the high-pressure hose in the holder (a) provided for this purpose as shown in Figure 14. Now wind up the hose evenly onto the hose reel using the crank handle (2). Before using the pressure cleaner, make sure that the high-pressure hose is completely unwound. When the motor starts to run hot, it is cut out by this switch. Wait 5-10 minutes before using the device again. try to determine the cause of the fault. If the problem repeats itself, please contact a customer service center. 3 Ordering replacement parts: Please quote the following data when ordering replacement parts: Type of machine Article number of the machine Identification number of the machine Replacement part number of the part required For our latest prices and information please go to www. Always pull out the mains power plug before starting any cleaning work. 1 Cleaning Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe the equipment with a clean cloth or blow it with compressed air at low pressure. We recommend that you clean the device immediately each time you have finished using it. Clean the equipment regularly with a moist cloth and some soft soap. Do not use cleaning agents or solvents; these could attack the plastic parts of the equipment. Ensure that no water can seep into the device. 16) Periodically check the intake filter in order to prevent clogging, which could jeopardize operation of the pump. To do this, unscrew the connection coupling for the water inlet hose from the device and clean the exposed inlet sieve by placing it under running water. 2 Long periods of nonuse (electric pump) If the machine is going to be stored for longer periods of time (i. Over 3 months) in a room where frost could develop, it is recommended that the machine be filled with an antifreeze solution (similar to the antifreeze solutions used for vehicles). When the device is not used for an extended period of time, lime deposits begin to form in the electric pump, which in turn can lead to starting difficulties. [. . . ] The original guarantee period remains applicable to the device even if repairs are carried out or parts are replaced. In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. This also applies when an on-site service is used. In order to assert your guarantee claim, please send your defective device postage-free to the address shown below. [. . . ]