User manual EINHELL RT-ID 105

[. . . ] Our warranty will be voided if the machine is used in commercial, trade or industrial businesses or for equivalent purposes. Mains voltage: Power input: Idling speed 1: Idling speed 2: Drilling capacity 230 V ~ 50 Hz 1050 W 0-1, 100 min-1 0-3, 000 min-1 Concrete 16 mm Steel 13 mm Wood 40 mm Protection class: Weight: II / 3. The corresponding safety information can be found in the enclosed booklet. Read all safety regulations and instructions. [. . . ] Benefits: The drill bit is easier to control when starting the hole and will not slide away. You avoid drilling messy holes (for example in tiles). 8/Item 6) The speed setting ring (6) enables you to define the maximum speed. The ON/OFF switch (5) can only be pressed to the defined maximum speed setting. Do not attempt to make this setting whilst the drill is in use. Switch the direction of the hammer drill using the clockwise/counter-clockwise switch (7): Direction Switch position Clockwise (forwards and drill) Pushed in to the right Counter-clockwise (reverse) Pushed in to the left 6. Always use HSS drill bits (HSS = high speed steel) and a low speed setting for drilling steel. We recommend that you lubricate the hole with a suitable cutting fluid to prevent unnecessary drill bit wear. 4 Starting holes If you wish to drill a deep hole in a hard material (such as steel), we recommend that you start the hole with a smaller drill bit. Switch the drill / hammer drill selector switch (3) to position B (hammer drill) as soon as the drill bit has passed through the tiles. 10) The speed selector switch (9) enables you to work within a specific speed range. Switch position, setting 1 (A) Speed range: High torque, low speed Switch position, setting 2 (B) Speed range: Low torque, high speed Important. Do not attempt to make this setting whilst the drill is in use. 7 Tips for working with your hammer drill 6. Always use carbide drill bits and a high speed setting for drilling into masonry and concrete. If the power cable for this equipment is damaged, it must be replaced by the manufacturer or its aftersales service or similarly trained personnel to avoid danger. Always pull out the mains power plug before starting any cleaning work. 1 Cleaning Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe the equipment with a clean cloth or blow it with compressed air at low pressure. We recommend that you clean the device immediately each time you have finished using it. Clean the equipment regularly with a moist cloth and some soft soap. Do not use cleaning agents or solvents; these could attack the plastic parts of the equipment. [. . . ] In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. This also applies when an on-site service is used. In order to assert your guarantee claim, please send your defective device postage-free to the address shown below. Please enclose either the original or a copy of your sales receipt or another dated proof of purchase. [. . . ]