User manual EINHELL RT-RH 24

[. . . ] We accept no liability for damage or accidents which arise due to non-observance of these instructions and the safety information. The tool is designed for drilling with hammer action in concrete, rock and brick, as well as for chiseling work, always using the respective correct drill or chisel bit. The equipment is to be used only for its prescribed purpose. Any other use is deemed to be a case of misuse. [. . . ] Otherwise there may be a risk of suffering an electric shock if you drill into cables. 6/Item 4) First fit a suitable drill bit into the tool (see 6. It may only be locked if the drill is set to rotate clockwise. 6/Item 4) You can infinitely vary the speed whilst using the tool. Select the speed by applying a greater or lesser pressure to the ON/OFF switch (4). Select the correct speed: The most suitable speed depends on the workpiece, the type of use and the drill bit used. Low pressure on the ON/OFF switch (4): Lower speed Greater pressure on the ON/OFF switch (4): Higher speed Tip: Start drilling holes at low speed. Benefits: The drill bit is easier to control when starting the hole and will not slide away. You avoid drilling messy holes (for example in tiles). 6/Item 11) The speed setting ring (11) enables you to define the maximum speed. The ON/OFF switch (4) can only be pressed to the defined maximum speed setting. set the speed using the setting ring (11) on the ON/OFF switch (4). Do not attempt to make this setting whilst the drill is in use. Switch the direction of the hammer drill using the clockwise/counter-clockwise switch (9): Direction Switch position Clockwise (forwards and drill) Pushed in to the right Counter-clockwise (reverse) Pushed in to the left If the power cable for this equipment is damaged, it must be replaced by the manufacturer or its aftersales service or similarly trained personnel to avoid danger. Always pull out the mains power plug before starting any cleaning work. 1 Cleaning Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe the equipment with a clean cloth or blow it with compressed air at low pressure. We recommend that you clean the device immediately each time you have finished using it. Clean the equipment regularly with a moist cloth and some soft soap. Do not use cleaning agents or solvents; these could attack the plastic parts of the equipment. Ensure that no water can seep into the device. The carbon brushes should not be rep laced by anyone but a qualified electrician. [. . . ] In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. This also applies when an on-site service is used. In order to assert your guarantee claim, please send your defective device postage-free to the address shown below. Please enclose either the original or a copy of your sales receipt or another dated proof of purchase. [. . . ]