User manual EIZO COLOREDGE CG210

[. . . ] Package Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Controls & Connectors . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . CABLE CONNECTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 2-1. Before Connecting. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Turn off the monitor's power by touching the power switch. Touch the power switch while touching the Enter switch, and this logo is not displayed. [To display] 1. Turn off the monitor's power by touching the power switch. Touch the power switch while touching the Enter switch, and this logo is not displayed again. 22 4. Screen Adjustment NOTE · Allow the LCD monitor to stabilize for at least 30 minutes before making image adjustments. The monitor displays the digital input image correctly based on its pre-setting data. Analog Input Screen adjustments for the LCD monitor should be used in suppressing screen flickering and also for adjusting the screen to its proper position. There is only one correct position for each display mode. It is also recommended to use the ScreenManager function when first installing the display or whenever changing the system. For convenience, an easy set-up Program installed on the utility disk to assist in the set-up procedure is provided. Adjustment Procedure 1 Touch the Auto Adjustment Switch on the control panel. The message appears and remains on the screen for 5 seconds. While the message is on the screen, touch the Auto Adjustment switch again to automatically adjust the clock, phase, screen position and resolution. If you do not wish to do adjust the screen, do not touch the Auto Adjustment switch again. Select <Resolution> and confirm if the resolution now being displayed is the same as the input resolution. If it is not, adjust the vertical resolution using the Up and Down switches and adjust thehorizontal resolution using the Right and Left switches. Smaller than the actual screen images Lager than the actual screen images 4 Adjust the output signal range (Dynamic Range) of the signal. Use the <Range Adjustment> of <Screen> menu. This controls the level of output signal range to display the whole color gradation (256 colors). [Procedure] Select the <Range Adjustment> in the ScreenManager and touch the Auto Adjustment switch on thecontrol panel to adjust the Range Adjustment. The screen blanks for a moment and adjusts the color range to display the whole color gradation of thecurrent output signal. 25 4. Displaying Lower Resolutions The lower resolutions are enlarged to full screen automatically. Using the <Screen Size> function in the <Others> menu enables to change the screen size. 1 Enlarge the screen size when displaying a low resolution. Select the <Screen Size>. Select the <Screen Size> in the others menu and select the screen size by using the up and down switches. Mode Function Full Displays the picture on the screen in full, irrespective of the picture's resolution. Since the verticalresolution and the horizontal resolution are enlarged at different rates, some images may appeardistorted. Displays the picture on the screen in full, irrespective of the picture's resolution. Since the vertical resolution and horizontal resolution are enlarged at same rates, some horizontal or vertical image maydisappear. [. . . ] * * * * Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. [. . . ]