User manual EIZO DURAVISION DV1208-002

[. . . ] The function "up / down scaling" makes it possible to show pictures with a lower or a higher resolution on the full screen. The integrated VESA DPMS power management system allows significant reduction in power consumption compared with the "normal" operation, if the computer disables the synchronization signal. Two versions of the monitor are available: · With AC power supply · Without AC power supply DV1208-002 DV1208-004 This manual was created to assist system integrators and operators during installation and operation of the LCD TFT Monitor DV1208. the layout is intended to allow even inexperienced users to install and set up the monitor. [. . . ] Most of the assemblies within the DV1208 LCD-monitor contain components, which can be destroyed by electrostatic voltages. It is also possible for the assemblies to be damaged in such a way that total failure does not occur. If you (as an authorized service technician) are handling such assemblies then the following precautions should be observed: · When electronic devices are handled, electrostatic discharge must be done before by e. This applies to all used (insulated) tools. If devices are removed or added to the system, the unit must always be switched off and the power supply cable unplugged. ⷠSensitive devices should always be held at their edge to avoid the touch of tracks and contact pins. Compare the received components with the delivery note · All unpacked delivered components should be checked for completeness and possible transport damage. If any deficiencies are found please contact the service department given on the delivery note, they need the delivery note number, serial number and a description of the deficiency. The original packaging should be kept for future transportation. In order to guarantee safe and interference-free operation the following points should be kept in mind during installation. Thermal Considerations In the ambient of the monitor the air should circulate to get a optimum operating temperature for the DV1208. Furthermore the air convection must be guaranteed This is very important for the rear of the unit. Please bear in mind that increased temperatures can lead to defects and to a significant reduction in the lifetime of the monitor. EMC Considerations This LCD monitor is a piece of equipment designed for building into an industrial system. The operator of the entire plant is responsible for maintaining electromagnetic compatibility according to EMC laws. Safety Considerations All voltage and signal connections must adhere to legal requirements. Ergonomics The screen should be easily viewable from all sides without reflections. Before connecting the DV1208 to the power supply, the signal should be plugged in properly and the screws have been tightened. The monitor can be connected directly to the power supply (check polarity of voltage connections). Pin 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Signal Video input RED Video input GREEN Video input BLUE Not used Not used GND (RED) GND (GREEN) GND (BLUE) Not used GND Not used Not used H-Sync. The cable from the AC/DC power supply unit (12 VDC) is plugged directly into the 12 VDC socket. It should be secured by using a pull-relief. [. . . ] The icon shows the following information's: signal source (e. VGA analog) mode number (internal mode number of the timing list) Image resolution of the input signal H- and V- frequency Red ­ green ­ blue - black on - off Inhibits new auto-alignment during display of a video signal when short-term noise is present on synchronous signals. The settings of this timing will always be used, even if variations in H- and V-frequency will occur by noise. The settings of this timing will always be used, even if variations in H- and V-frequency will occur by noise. [. . . ]