User manual EIZO FLEXSCAN F931

[. . . ] ENGLISH 1 SAFETY SYMBOLS This manual uses the safety symbols below. Please read them carefully. WARNING Failure to abide by the information in a WARNING may result in serious injury and can be life threatening. CAUTION Failure to abide by the information in a CAUTION may result in moderate injury and/or property or product damage. Indicates a prohibited action. Indicates to ground for safety. Copyright© 2001 by EIZO NANAO CORPORATION. No part of this manual may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, or otherwise, without the prior written permission of Eizo Nanao Corporation. [. . . ] Connecting two PCs to the Monitor Two PCs can be connected to the monitor through the BNC/D-Sub input connections on the back of the monitor. (Example) Standard graphics board Apple Macintosh (Blue & White) MD-C53A (Optional) 1. Selecting the active input Every time the BNC/D-Sub selection button is pressed, the input changes in order. [Automatically selecting the input signal for screen] The monitor will automatically detect the inputted signal of either the BNC or D-SUB connection for display. When turning on the monitor, the first inputted signal will be displayed. (1) Select <Input Signal> in the <Others> menu. Saving the adjustment data The adjustment data can be saved for both signals. However, the following adjustment and setting data can be saved for each input signal (BNC/D-Sub). <Contrast>, <Fine Contrast>, <Temperature>, <Custom>, <Signal Filter 1> and <Signal Filter 2> 3. TROUBLESHOOTING If a problem persists even after applying the suggested remedies, contact an EIZO dealer. *The bracket < > indicates the function of ScreenManager Problems 1. No picture · Indicator status: Off Points to check with possible solutions Check that the power cord is correctly connected. If the problem persists, turn off the monitor power for a few minutes, then turn it back on and try again. Try pressing a key on the keyboard, or clicking the mouse. 16) Try pressing the AUTO-SIZING button or control pad or turn the monitor off and then on. 16) These messages appear when the signal is not inputted correctly, even if the monitor functions properly. Error messages will remain on the screen for 30 seconds. When the image is displayed correctly after a short time, it is not a monitor's problem. (Some PC does not output the signal soon after powering on). Check that the signal cable is properly connected to the PC or graphics board. Switch the signal input by pressing the BNC/D-Sub selection button on the front control panel. Use the graphics board's utility software to change the frequency setting. (Refer to the manual of the graphics board). · Indicator status: Green · Indicator status: Flashing Green / Yellow · Indicator status: Flashing Yellow 2. [. . . ] Lead damages the nervous system and in higher doses, causes lead poisoning. The relevant TCO'99 requirement permits the inclusion of lead since no replacement has yet been developed. * Bio-accumulative is defined as substances which accumulate within living organisms. ** Lead, Cadmium and Mercury are heavy metals which are Bio-accumulative. For U. S. A, Canada, etc. (rated 100-120 Vac) Only FCC Declaration of Conformity We, the Responsible Party EIZO NANAO TECHNOLOGIES INC. [. . . ]