User manual EIZO FLEXSCAN L788-I

[. . . ] (rated 100-120 Vac) Only FCC Declaration of Conformity We, the Responsible Party EIZO NANAO TECHNOLOGIES INC. 5710 Warland Drive, Cypress, CA 90630 Phone: (562) 431-5011 Trade name: EIZO Model: FlexScan L788 declare that the product is in conformity with Part 15 of the FCC Rules. Operation of this product is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] Displays the picture at the actual screen resolution. Enlarged Normal Example: Displaying 1024 × 768 Full (Default Setting) Enlarged Normal (1280 × 1024) (1280 × 960) (1024 × 768) 2. Smooth the blurred texts of the enlarged screen. Switch the <Smoothing> setting. Select the suitable level from 1 - 5 (Soft - Sharp). Select <Smoothing> in the <Screen> menu and adjust by using the right and left buttons. NOTE <Smoothing> is disabled when the screen is displayed in the following resolutions. *1280 × 1024 *The image size is doubled both in horizontally and vertically to (i. e. 1280 × 960 enlarged from 640 × 480) provide clear focus which does not require this function. 4. ADJUSTMENT 27 English 3. Set the brightness of the black area surrounding the displayed image. Set the <Border Intensity>. In the <Enlarge> mode or <Full Screen> mode, the outer area (border) is usually black. Select <Border Intensity> in the <Others> menu and adjust by using the right and left buttons. Border 28 4. Color Adjustment Color adjustments are provided in ScreenManager <Color Management> menu. To customize monitor color, select <Custom> through the <Color Mode>. To configure monitor color to sRGB standard, select <sRGB> through the <Color Mode>. Color mode can also be switched to other if pressing Mode button of the control panel. In the analog input, perform the "Range Adjustment" (p. 26) before making the color adjustments. NOTE Allow the LCD monitor to stabilize for at least 30 minutes before making image adjustments. Performing the <Reset> of the <Color> menu returns the color settings of the selected mode to the default settings. The values shown in percentages represent the current level within the specific adjustment. They are available only as a reference tool. (To create a uniform white or black screen, the percentages for each will probably not be the same. ) <Custom> Mode - customizing monitor color Adjustment Contents 0 Menu Brightness Function Descriptions To set the brightness of the screen 0 ~ 100 % Adjustable range NOTE The values shown in the percentage are available only as a reference tool. Contrast To adjust the screen gradation higher or lower 0 ~ 100 % NOTE The values shown in the percentage are available only as a reference tool. 4. ADJUSTMENT 29 English Menu Temperature (p. 44) Function Descriptions To set the color temperature Adjustable range 4000 ~ 10000 K in 500 K increments (including 9300 K). NOTE Setting the value to "Off" presents the natural color temperature of the panel. The values shown in the Kelvin are available only as a reference tool. [. . . ] The relevant TCO'99 requirement states that batteries may not contain any mercury. It also demands that mercury is not present in any of the electrical or electronics components associated with the labelled unit. CFCs (freons) The relevant TCO'99 requirement states that neither CFCs nor HCFCs may be used during the manufacture and assembly of the product. CFCs (freons) are sometimes used for washing printed circuit boards. [. . . ]