User manual EIZO LA-120-D

[. . . ] Not doing so may cause the arm or monitor to fall, which may result in injury or equipment damage. Not doing so may cause the monitor to fall and result in injury or equipment damage. Do not affix the arm on such a base as shown below or on a weak base which cannot support the monitor or arm. Affixing the arm on these bases may cause the monitor to fall and result in injury. Not hooking enough On tapered desk On Pole On Wall Clamp the screws of the arm tightly. [. . . ] After clamping the arm, covering the screw holes with Stand Mounting cover. Fit the holes Press against the desk Desk NOTE The arm may not affix firmly to the base if driving either screw in tightly. If attaching the LA-120-D, bend the arm slightly forward in advance. Not doing so may scratch the arm by a hex-head wrench. 3. Attach the monitor to the arm. Use specified screws for tightening up between arm, fitting and monitor referring to the back of this manual. <The monitor employing 75 mm x 75 mm arm mounting holes> (1) Attach the arm to the monitor with specific screws (M4 x 8 (black) or M4 x 12 (silver/long), 4 points). (2) Put in the covers to the shield plate with sliding them rightward or leftward. (1) (2) NOTE Adjust the angle of the monitor to face upward slightly so that the cover can be mounted easily. <The monitor employing 100 mm x 100 mm arm mounting holes> (1) Mount the fitting on the rear of monitor with specific screws (M4 x 8 (black) or M4 x 12 (silver/long), 4 points). (2) Hook the monitor with fitting of to the arm. (3) Attach the arm to the monitor with fitting by using screws (M4 x 8 (silver/short), 4 points). (4) Put in the covers to the shield plate with sliding them rightward or leftward. (1) (2) (3)(4) NOTE Adjust the angle of the monitor to face upward slightly so that the cover can be mounted easily. 4. Lead the power cord and signal cable into the cable holder at inner side of the arm. [LA-130-D] [LA-120-D] Cable Holder Cable Holder NOTE The number of cable holder may differ from each model. The cables are recommended to lead with slight sag for the smooth motion of the monitor for portrait display. Specifications____________________________________ LA-130-D Dimension (W) x (H) x (D) Weight 130 (5. 1) x 303. 8 ~ 466. 1 (12. 0 ~ 18. 4) x 275. 6 ~ 495. 8 (10. 9 ~ 19. 5) mm (inch) 2. 8 kg / 6. 2 lbs Dimensions Unit: mm (inch) Top Side Front LA-120-D Dimension (W) x (H) x (D) Weight 130 (5. 1) x 259. 2 ~ 421. 5 (10. 2 ~ 16. 6) x 130. 6 ~ 350. 8 (5. 1 ~ 13. 8) mm (inch) 2. 5 kg / 5. 5 lbs Dimensions Unit: mm (inch) Top Side Front NOTE The value within the dimensions drawing is only for reference, and range of motion may differ according to the installed condition. LIMITED WARRANTY EIZO NANAO CORPORATION ("EIZO") and EIZO's authorized distributors warrant to the original purchaser that this product shall be free from defects in material and workmanship for a period of one (1) year from the date of purchase. The service parts stock for the product shall be maintained for five (5) years after the production is discontinued. This warranty is valid only in the countries where EIZO's authorized distributors are located. In the event of malfunction of the product during the warranty period attributable directly to defective material and/or workmanship, EIZO and EIZO's authorized distributors will, at their option, either repair or replace the defective product. EIZO and EIZO's authorized distributors shall have no obligation under this warranty, however, in the following cases: (a) Any defect of the product caused by freight damage, modification, alteration, abuse, misuse, accident, incorrect installation, disaster, faulty maintenance or improper repair by third party other than EIZO and EIZO's authorized distributors. (b) Any incompatibility of the product due to possible technical innovations or regulations. (c) Any deformation, discoloration, warp, loss of brightness or focus, or whatsoever due to normal deterioration of the product. (d) Any defect of the product caused by external equipment. (e) Any defect of the product on which the original serial number has been altered or removed. (f) Any exchange of products due to the normal depletion of consumables such as batteries. [. . . ] Weitere Informationen finden Sie auch unter der Internet-Adresse: www. eizo. de. Recycling Information for customers in Switzerland: All recycling information is placed in the SWICO's website. http://www. swico. ch Recycling-Information für Kunden in der Schweiz: Alle Informationen zum Thema Recycling finden Sie auf der Homepage des Brancheverbandes SWICO. http://www. swico. ch Renseignements de recyclage pour les clients en Suisse: Vous trouvez tous les renseignements pour le sujet de recyclage sur la page WEB de I'UNION DE BRAN CHE SWICO. [. . . ]