User manual ELECTRIX MO-FX

[. . . ] CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN A T T E N T I O N : RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR W A R N I N G : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated ìdangerous voltageî within the productís enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within a equilateral triangle is intended to alert the uset to the presence of importat operating and maintenance (sevicing) instruction in the literature accomanying the product. INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSON IMPORTANT SAFETY INSTRUCTIONS READ AND SAVE THESE INSTRUCTIONS WARNING - When using electric products, basic precautions should always be followed, including the following: 1. Read all the instructions before using the product. Do not use this product near water - for example near a bathtub, washbowl, kitchen sink, in a wet basement, or near a swimming pool, or the like. [. . . ] The combinations are represented by 3 LED for High, Mid, and Low. The combinations are: All bands, High, Mid, Low, Low+High, Low+Mid, High+Mid. Note: Every time the Band button is pressed MO-FX will cycle to the next combination. However, at any point in the cycle the Band button can be held down for 500ms and it will return directly to All bands. " Band: Selects between 7 combinations of frequency bands the tremolo will effect. The combinations are represented by 3 LED for High, Mid, and Low. The combinations are: All bands, High, Mid, Low, Low+High, Low+Mid, High+Mid. Note: Every time the Band button is pressed MO-FX will cycle to the next combination. However, at any point in the cycle the Band button can be held down for 500ms and it will return directly to All bands. GLOBAL TIME SYNCHRONIZATION " Tap Tempo/Sync: The Tap Tempo Button, when used in conjunction with the effect block sync buttons, will synchronize the rate of each block's effect to the beat of the music. Tapping the button twice (or more) to the beat will establish the tempo of the song. Tapping 3 or more times can give a more accurate tempo as an average tempo is created from all the taps. The tempo is displayed by flashing the LED around the Tap Tempo button on the beat. The LED will also flash to the beat when MIDI clock is present. Note: If taps are more than 2 seconds apart the Tap Tempo will start calculating a new tempo. If you are having difficulty establishing a new tempo, wait for two seconds then tap a new tempo. This will clear the Tap Tempo averaging buffer, and the Tap Tempo LEDs will flash in time with the new tempo. DELAY MO-FX's digital Delay can produce some wild sounds. Unlike most digital delays, it emulates the pitch shifting effect of analog delay but with the added fidelity of its digital signal path. By turning the regeneration control all the way up, you can use the Delay section as a simple sampler. " Engage: Toggles the delay effect in and out. " Momentary: Temporarily engages the delay effect. This is useful for creating short burst of delay for rhythmic accents. The momentary essentially reverses the state of the engage switch. When an effect is engaged, the momentary will dis-engage it. When an effect is not engaged the momentary will engage it. " Mix: Sets the Wet / Dry mix of the Delay Block. [. . . ] It may be necessary to manually tell MO-FX to respond to the incoming MIDI clock. Tremolo Tremolo Tremolo Tremolo Tremolo Tremolo "To sync MO-FX to incoming MIDI clock, press and hold the Tap Tempo Button for 600ms. "MIDI clock does not always indicate the down beat. Hit MO-FX's Tap Tempo button, while receiving MIDI clock to re-sync MO-FX to the down beat. 4. MIDI 4. 3 MIDI IMPLEMENTATION CHART 5. [. . . ]