User manual ELECTRO-VOICE 7300A

[. . . ] The new vocally optimized bass or VOBÔ technology provides the instrumentalist with reduced resonant distortion at low frequencies. Critical damping of the low frequency resonant peak has resulted in a microphone that replaces the muddiness found in competitive models with greater warmth and increased clarity. [. . . ] The result is a exceptional performing instrument microphone with clean, clear, consistent sound that cuts through the mix. Usage Electric Guitar and Bass Guitar Amplifier Place Optimal Placement microphone approximately 1-2 from and at a 90° degree angle to the speaker cone. To reduce boominess, move the microphone off axis to the cone from 90° to 45°, or move mic from center of cone to either edge. _ VOBÔ technology provides tailored bass response for controlled proximity effect and exceptional sound clarity Tom-Toms On double headed Toms place mic over the top of drum 1-3 and at a 45° angle to the drum surface and 1-2 in from the drum edge. On single headed Toms use above method or place mic inside Tom from underneath at a 90° angle from the center of head, 3-5 away. _ Excellent choice for micing acoustical or electrical instruments whether in a live sound or studio environment _ Neodymium based magnet provides greater sensitivity and signal to noise ratio _ Cardioid pattern for superior feedback rejection and acoustic isolation Snare Drum Place mic 1-3 above the heads, 1-2 in from the rim. Aim each mic at the top heads angled down about 45°. If the _ Warm Gripä handle for comfortable feel and lower handling noise drum rings, tape deadening material to the head or use damping rings. For more Operation The low frequency response of the N/D478 microphone varies with the distance from the sound source. Non-reflecting black Materials: MemraflexTM grille screen Warm-GripTM handle Dimensions: Length. @ 18. 6 oz (545 grams) Accessories included: Stand adapter (black) Soft zippered gig bag Always point the microphone at the desired source of sound, and away from any unwanted sources. 2. The microphone should be located close to the sound source to minimize interference from other potential sound sources. â magnet structure 3. Use the 3-to-1 rule when using multiple microphones. sound source. Place each microphone three times farther from other microphones as from the desired 4. Minimize over-handling of the microphone to reduce unwanted mechanical noise 5. Working close to the microphone will increase the bass tone and also provide increased gain-before-feedback. Warranty This product is guaranteed against malfunction from any cause for two (2) years from the date of original purchase. In addition, the Limited Warranty for the acoustic system contained in the microphone shall apply for the life of this product, defines as a period of ten (10) years from the date that the manufacture of this microphone model has been discontinued. Any and all active electronics incorporated in this microphone are guaranteed against malfunction due to material workmanship for a period of three (3) years from the date of original purchase. This Limited Warranty does not extend to cables, connectors, or switches. For warranty service please call us at: 616-695-6831 or 1-800-234-6831 USA 9600AldrichAve. S. , Minneapolis, MN 55420, Phone:612/884-4051, AX:612/884-0043 F Canada 705ProgressAvenue, Unit10, Scarborough, Ontario, Canada, M1H2X1, hone:416-431-4975, FAX:416-431-4588 P Switzerland Keltenstrasse11, CH-2563 IPSACH, Switzerland, Phone:011-41/32-331-6833, AX:011-41/32-331-1221 F German y HirschbergerRing 45, D94302, Straubing, Germany, Phone:011-49/9421-7060, FAX:011-49/9421-706265 France Parcde Courcerin, AlleeLech Walesa, Lognes, f-77185Marne La Vallee, France, Phone:011-33/1-6480-0090, AX:011-33/1-6006-5103 F Australia Unit23, SloughBusinessEstate, Silverwa terN. S. W. [. . . ] Any and all active electronics incorporated in this microphone are guaranteed against malfunction due to material workmanship for a period of three (3) years from the date of original purchase. This Limited Warranty does not extend to cables, connectors, or switches. For warranty service please call us at: 616-695-6831 or 1-800-234-6831 USA 9600AldrichAve. S. , Minneapolis, MN 55420, Phone:612/884-4051, AX:612/884-0043 F Canada 705ProgressAvenue, Unit10, Scarborough, Ontario, Canada, M1H2X1, hone:416-431-4975, FAX:416-431-4588 P Switzerland Keltenstrasse11, CH-2563 IPSACH, Switzerland, Phone:011-41/32-331-6833, AX:011-41/32-331-1221 F German y HirschbergerRing 45, D94302, Straubing, Germany, Phone:011-49/9421-7060, FAX:011-49/9421-706265 France Parcde Courcerin, AlleeLech Walesa, Lognes, f-77185Marne La Vallee, France, Phone:011-33/1-6480-0090, AX:011-33/1-6006-5103 F Australia Unit23, SloughBusinessEstate, Silverwa terN. S. W. [. . . ]