User manual ELECTRO-VOICE DC50 DATASHEET

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

Sponsored Links

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual ELECTRO-VOICE DC50. We hope that this ELECTRO-VOICE DC50 user guide will be useful to you.

Lastmanuals help download the user guide ELECTRO-VOICE DC50.


ELECTRO-VOICE DC50 DATASHEET: Download the complete user guide (539 Ko)

Manual abstract: user guide ELECTRO-VOICE DC50DATASHEET

Detailed instructions for use are in the User's Guide.

[. . . ] Input channels 1-10 are designed to either be used as low-Z balance microphone or line level inputs. The combination connector on inputs 1-10 permits use of either XLR or ¼" input connectors. [. . . ] The combination connector on inputs 1-10 permits use of either XLR or ¼" input connectors. The block diagram shown in Figure 2 outlines the signal flow for the MA-1206. A signal appearing at either input 1 will automatically mute the other channels unless the mute function is defeated via a switch on the rear panel. Inputs 11 and 12 are for auxiliary line-level sources such as tape or CD players. The left and right components of a stereo signal can be applied to the dual RCA phono jacks of these inputs and mixed together to drive the builtin monaural power amplifier. A rear panel paging input with gain control is provided for the paging output of a telephone system. The mute circuit shall be defeatable using a switch on the rear panel. Inputs 1 - 10 shall be available via combination female XLR / ¼" connectors. If a stereo source is connected, it shall be properly mixed to mono via a resistor network mounted on the input plate. There shall be a paging input that accepts a 600-ohm linelevel feed from a phone system. When a signal is present Technical Specifications: Power Output (at 1 kHz): 120 Watts Frequency Response: 50 Hz - 15 kHz, ±3 dB Input Sensitivity/Impedance, Inputs 1-10 Mic setting: 0. 3 mV/600 ohm (balanced) Inputs 1-10 Line setting: 75 mV/47kohm (balanced) Paging: -20 dBm/600 ohm (transformer isolated) Power Amp In: 1 V/10 kohm (unbalanced) Aux: 100 mV to 1V/ (unbalanced) THD (at rated output): <1% at 1 kHz Signal-to-Noise Ratio, Mic : >52 dB Aux: > 65 dB Paging: > 65 dB Power Amp In: >90 dB Line Output Level/Impedance, Preamp Output: 1 V/1 kohm (unbalanced) Balanced Line Output: 500 mV/47 kohm (unbalanced) Speaker Outputs: 4, 8, 16 ohm, 25, 70. 7 and 100-Volt Tone Controls, Bass: +-10 dB at 100 Hz Treble: +-10 dB at 10 kHz Muting: 40 dB attenuation Protection : 3 independent Slo-Blo ® fuses, primar y ac and dc Power Dissipation: 390 watts Power Supply: 108-132 V ac, 50/60 Hz Dimensions, Height: 13. 3 cm (5. 2 in. ) Width: 48. 0 cm (18. 9 in. ) Depth: 32. 0 cm (12. 6 in. ) Net Weight: 11. 5 kg (25. 4 lb) Shipping Weight: 12. 7 kg (27 lb) Rear View 12000 Portland Avenue South, Burnsville, MN 55337 Phone:952/884-4051, Fax:952/884-0043 www. electrovoice. com © Telex Communications, Inc. For customer orders, contact Customer Service at: 800/392-3497 Fax: 800/955-6831 Europe, Africa, and Middle East only. [. . . ] When a signal is present Technical Specifications: Power Output (at 1 kHz): 120 Watts Frequency Response: 50 Hz - 15 kHz, ±3 dB Input Sensitivity/Impedance, Inputs 1-10 Mic setting: 0. 3 mV/600 ohm (balanced) Inputs 1-10 Line setting: 75 mV/47kohm (balanced) Paging: -20 dBm/600 ohm (transformer isolated) Power Amp In: 1 V/10 kohm (unbalanced) Aux: 100 mV to 1V/ (unbalanced) THD (at rated output): <1% at 1 kHz Signal-to-Noise Ratio, Mic : >52 dB Aux: > 65 dB Paging: > 65 dB Power Amp In: >90 dB Line Output Level/Impedance, Preamp Output: 1 V/1 kohm (unbalanced) Balanced Line Output: 500 mV/47 kohm (unbalanced) Speaker Outputs: 4, 8, 16 ohm, 25, 70. 7 and 100-Volt Tone Controls, Bass: +-10 dB at 100 Hz Treble: +-10 dB at 10 kHz Muting: 40 dB attenuation Protection : 3 independent Slo-Blo ® fuses, primar y ac and dc Power Dissipation: 390 watts Power Supply: 108-132 V ac, 50/60 Hz Dimensions, Height: 13. 3 cm (5. 2 in. ) Width: 48. 0 cm (18. 9 in. ) Depth: 32. 0 cm (12. 6 in. ) Net Weight: 11. 5 kg (25. 4 lb) Shipping Weight: 12. 7 kg (27 lb) Rear View 12000 Portland Avenue South, Burnsville, MN 55337 Phone:952/884-4051, Fax:952/884-0043 www. electrovoice. com © Telex Communications, Inc. For customer orders, contact Customer Service at: 800/392-3497 Fax: 800/955-6831 Europe, Africa, and Middle East only. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE ELECTRO-VOICE DC50

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual ELECTRO-VOICE DC50 will begin.

Search for a user manual

 

Copyright © 2015 - LastManuals - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.

flag