User manual ELECTRO-VOICE SL 6.2M DATASHEET
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual ELECTRO-VOICE SL 6.2M. We hope that this ELECTRO-VOICE SL 6.2M user guide will be useful to you.
Lastmanuals help download the user guide ELECTRO-VOICE SL 6.2M.
Manual abstract: user guide ELECTRO-VOICE SL 6.2MDATASHEET
Detailed instructions for use are in the User's Guide.
[. . . ] These components provide wide dynamic range, smooth coverage, and exceptional reliability. One person installation is simple using the included EV Strong-Arm-MountTM. [. . . ] No sound Amplifier Possible Cause(s) Action
Attach both logo caps as shown in Figure 8 after tightening and securing the speaker.
EV logo cap (large)
EV logo cap (small)
Connect a known working test speaker to the amplifier outputs. If there is no sound, check that all the electronics are on, the signal routing is correct, the source is active, the volume is turned up, and so on. Verify that you have connected the correct wire pairs to the amplifier. Play something at low level through the amplifier (for example, from a CD player or tuner). If the sound has gone or is very weak, the line has a short in it (possibly a severe scrape, pinch, or staple puncture). If the sound level is normal, the wire is open (possibly a cut wire or a missed connection). Using the test speaker, move down the line and test each connection/junction until you find the problem and correct it. Observe proper polarity.
The rear of the enclosure includes an eyebolt for connection to a seismic restraint. Connect it to a properly rated hardware fitting that is securely installed independently of the SAMTM bracket. Even if your local construction code does not require the installation of secondary support, its use is highly recommended for further security. Poor lowfrequency response
Connect seismic security cable
Step 3: Wire the Speaker
Speakers wired out-of-polarity
Connect the wires to the speaker at the back terminal plate observing the polarity of the connections. The push-terminals accept banana connector plugs.
When two speakers are connected out of polarity (out of phase), the low frequencies will cancel each other acoustically. [. . . ] The support bracket shall be low profile and integral with the enclosure.
Frequency Response and Impedance:
Directivity: Dimension Drawings:
U. S. A. For customer orders, contact Customer Service at: 800/392-3497 Fax: 800/955-6831 Europe, Africa, and Middle East only. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE ELECTRO-VOICE SL 6.2M
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual ELECTRO-VOICE SL 6.2M will begin.