User manual ELECTRO-VOICE XI-2123A106F EDS

[. . . ] Xi-2123A/106F Dual 12-Inch Three-Way, Full-Range 100° x 60° Sound Reinforcement System Key Features: · · · · · · · · · · · Compact/High-Level, Three-Way Design VBS Capable Dual DL12ST 12" Slot-Loaded LowFrequency Drivers DL10X 10" Horn-Loaded Mid-Bass Driver ND6-16 3" Diaphragm HF Compression Driver 100° x 60° High-Frequency Coverage Triamp or Biamp Operation Fully Rotatable HF and MB Sections for Vertical or Horizontal Suspension Ring-Mode Decoupling / RMDTM Built-In L-Track Rigging Available in Black or White General Description: The Electro-Voice Xi-2123A/106F is a triamp-ready, threeway system in a unique three-element-line-array configuration designed for use in reverberant spaces. [. . . ] For applications requiring very high low-frequency sound pressure levels as well as very accurate vocal reproduction, the Xi-2123A/106 may be coupled with the Electro-Voice Xi1191A or Xi-2181A. ® Technical Specifications: Freq. Range1 (-10 dB): 50 Hz - 19 kHz Max Calculated SPL2: 138 dB Coverage: 100° x 60° (Rotatable) LF Power Handling: 600W Continuous, 2400W Peak MB Power Handling: 300W Continuous, 1200W Peak HF Power Handling: 75W Continuous, 300W Peak LF Sensitivity: 100 dB, 1W/1m MB Sensitivity: 107 dB, 1W/1m HF Sensitivity: 112 dB, 1W/1m LF Impedance: 4 ohms (Nominal) MB Impedance: 8 ohms (Nominal) HF Impedance: 16 ohms (Nominal) LF Transducer: 2 x DL12ST 12" (305mm) Drivers, 8 ohms MB Transducer: DL10X 10" (254mm) Driver, 8 ohms HF Transducer: ND6-16 3" (76mm) Diaphragm Comp. Driver, 16 ohms Crossover Frequency3: Use Recommended Parameters Connectors: Two Neutrik Speakon® NL8MPR Enclosure Material: 13-ply Birch plywood Grille: 16 GA steel Dim (H x W x D): 1007 x 458 x 473 mm (39. 7" x 18. 0" x 18. 6") Net Weight: 63. 6 kg (140 lbs) Shipping Weight: 65. 8 kg (145 lbs) 1 2 3 Full Space measurement with a Dx38 Controller Max Calculated SPL of MB Section Download at www. electrovoice. com Xi-2123A/106F Full Range Loudspeaker (3-Way) Frequency Response (Full & Half Space): Impedance: Beamwidth (3-Way): Horizontal Off Axis Frequency Response: Beamwidth with VBS (Tripole): Vertical Off Axis Frequency Response (Up): Directivity (3-Way): Vertical Off Axis Frequency Response (Down): Directivity with VBS (Tripole): Engineering Data Sheet Horizontal 1/3 Octave Polars (3-Way): Vertical 1/3 Octave Polars (3-Way): Dimension Drawings: Wiring/Connection Chart: Triamp to Biamp - Switch 4-Pin Connector on inside of Input Panel. Triamp LF: Pins 1 In Pins 2 Out MB: Pins 3 In Pins 3 Out HF: Pins 4 In Pins 4 Out Biamp LF: Pins 1 In Pins 2 Out MB/HF: Pins 3 In Pins 3 Out Pins 4 Pass Through Pins 2 In Connected to Pins 1 Out CAUTION This Xi Loudspeaker should be suspended overhead only in accordance with the procedures and limitations specified in the X-Array Xi Install Flying Manual and possible manual update notices. This system should be suspended with certified rigging hardware by an authorized rigging professional and in compliance with local, state, and federal overhead suspension ordinances. Performance Match Xi-2123A/106F Part Numbers · · 1149-3416 - Black 1149-3410 - White Architectural & Engineering Specs: · P3000 (RL) · CPS 2. 8 · Dx38 · P1200 (RL) · CPS 2. 11 The loudspeaker system shall be a three-way tri-amp or bi-amp system. The system shall have two (2) 12-inch, low-frequency loudspeakers with a nominal impedance of 4 ohms and 2. 5-inch voice coils. The low-frequency loudspeakers shall have a power handling capacity of 600 watts for 8 hours (as per ANSI/EIA RS-426 A & AES 2-1984). The mid-bass loudspeaker shall be a fully horn loaded, 10-inch driver with a 2. 5-inch voice coil and a nominal impedance of 8 ohms. The mid-bass driver shall have a power-handling capacity of 300 watts for 8 hours (as per ANSI/EIA RS-426 A). [. . . ] For customer orders, contact Customer Service at: + 1 952 884-4051 Fax: + 1 952 736-4212 For warranty repair or service information, contact the Service Repair department at: 800/685-2606 For technical assistance, contact Technical Support at: 866/78AUDIO Specifications subject to change without notice. [. . . ]