User manual ELECTROLUX EHG30215X

[. . . ] Com Contents Safety information Installation Description of the appliance Operating the appliance Helpful hints and tips 20 22 25 25 26 Care and cleaning What to do if… Technical data Environment concerns 26 27 28 28 Subject to change without notice Safety information Warning!These instructions are only valid in the countries whose symbols appear on this booklet's cover. For your safety and correct operation of the appliance, read this manual carefully before installation and use. Always keep these instructions with the appliance even if you move or sell it. [. . . ] Gas Connection Choose fixed connections or use a flexible pipe in stainless steel in compliance with the regulation in force. If you use flexible metallic pipes, be careful they do not come in touch with mobile parts or they are not squeezed. Also be careful when the hob is put together with an oven. Make sure that the gas supply pressure of the appliance obeys the recommended values. The adjustable connection is fixed to the comprehensive ramp by means of a threaded nut G 1/2". Screw the parts without force, adjust the connection in the necessary direction and tighten everything. 1 2 3 2 4 1 End of shaft with nut 2 Washer (additional washer is only for Slovenia and Turkey) 3 Elbow 4 Rubber pipe holder for liquid gas (only for Slovenia and Turkey) Rigid connection: Carry out connection by using metal rigid pipes (copper with mechanical end). "Flexible" connection with mechanical end: – Natural gas : connection carry out with a flexible pipe with mechanical end which is screwed directly on the elbow finishing the slope of the appliance. Electrolux 23 – Butane / Propane : use a flexible tube, equipped with it's collars if it is worth visiting over all it's length and if the appliance runs only on butane. If the appliance runs on Propane, use a flexible pipe with suitable metal end. Flexible nonmetal pipes connection: If it is possible to easily control the connection in its full area, you can use a flexible pipe. The flexible pipe is prepared for apply when: – it can not get hot more than room temperature, higher than 30°C; – it is no longer than 1500 mm; – it shows no throttles; – it is not subject to traction or torsion; – it does not get in touch with cutting edges or corners; – it can be easily examined in order to check its condition. The control of preservation of the flexible pipe consists in checking that: – it does not show cracks, cuts, marks of burnings on the two ends and on its full length; – the material is not hardened, but shows its correct elasticity; – the fastening clamps are not rusted; – expired term is not due. If one or more defects are visible, do not repair the pipe, but replace it. When installation is complete, make sure that the seal of each pipe fitting is correct. Remove the caps and crowns of the burner. With a socket spanner 7 remove the injectors and replace them with the ones which are necessary for the type of gas you use (see table in Technical Data section). Assemble the parts, follow the same procedure backwards. Replace the rating label (it is near the gas supply pipe) with the one for the new type of gas supply. You can find this label in the package of the injectors supplied with the appliance. If the supply gas pressure is changeable or different from the necessary pressure, you must fit an applicable pressure adjuster on the gas supply pipe. Adjustment of minimum level To adjust the minimum level of the burners: 1. [. . . ] After cleaning, dry the appliance with a soft cloth. €“ Stop the appliance and let it cool down before you clean: limescale rings, water rings, fat stains, shiny metallic discolorations. Use a special cleaner for glass ceramic or stainless steel. Clean the appliance with a damp cloth and some detergent. [. . . ]