User manual ELECTROLUX EHX9565FOK

[. . . ] You’ve chosen a product that brings with it decades of professional experience and innovation. ingenious and stylish , it has been designed with you in mind. So whenever you use it, you can be safe in the knowledge that you’ll get great results every time. Get usage advice, brochures, trouble shooter, service information: www. [. . . ] Touch of the timer to choose one of the following: • - the sounds are off - the sounds are on • To confirm your selection wait until the hob deactivates automatically. When the function is set to hear the sounds only when: • • • • you can 4. 9 Lock You can lock the control panel while cooking zones operate. You touch Minute Minder comes down Count Down Timer comes down you put something on the control panel. 12 Power management function • Cooking zones are grouped according to the location and number of the phases in the hob. € The function divides the power between cooking zones connected to the same phase. € The function activates when the total electricity loading of the cooking zones connected to a single phase exceeds 3700 W. € The function decreases the power to the other cooking zones connected to the same phase. € The heat setting display of the reduced zones changes between two levels. When you switch between the modes the heat setting is set back to 0. Diameter and position of the cookware Choose the mode applicable to the size and the shape of the cookware. The cookware should cover the selected area as much as possible. Place the cookware centrally on the selected area!Place the cookware with the bottom diameter smaller than 160 mm centrally on a single section. The sections can be combined into two cooking zones with different size, or into one large cooking area. You choose the combination of the sections by choosing the mode applicable to the size of the cookware you want to use. There are three modes: Standard (activated automatically when you activate the hob), Big Bridge and Max Bridge. To set the heat setting use two left side control bars. Switching between the modes To switch between the modes use sensor field: . 100-160mm Place the cookware with the bottom diameter larger then 160 mm centrally between two sections. 3 FlexiBridge Big Bridge mode To activate the mode press until you see the correct mode indicator. This mode connects three rear sections into one cooking zone. [. . . ] € To replace the damaged mains cable use the following (or higher) mains cable type: H05BB-F Tmax 90°C. 2 Built-in hobs Only use the built-in hobs after you assemble the hob into correct built-in units 20 www. Clean the worktop around the cut out area. Attach the supplied seal stripe to the lower edge of the hob along the outer edge of the glass ceramic. [. . . ]