User manual ELECTROLUX EKM7300

[. . . ] Appliances can be used by persons with reduced physical, sensory or mental capabilities DA Or lack of experience and knowledge if they have been given supervision or instruction DE Concerning use of the appliance in a safe way and if they understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. The appliance may only be connected to a power supply whose voltage and frequency Comply with the specifications on the rating plate! [. . . ] Place the processing bowl onto Keep it away from the Press the lever (A) downwards, the motor head will then be lifted. The motor base (the bowl will only fit correctly on the base when the Be sure to leave plenty of room around air vents at the back of the appliance. Warning: Keep fingers and hands away from areas with movable parts. Note: As a safety precaution, once you move the motor head up, it locks into that position. Note: If difficult to release locking Function, gently push motor head Place tool (A) on the tool shaft (B): Align the pin at the top of the tool And turn it counterclockwise until the Attachment, push upwards, move it Tilting the Motor head down: gently press the lever (A) down and slide the motor head (B) downwards with your other hand until it locks into correct position. Gently push the cover down until it locks into place. Only add ingredients using the pouring hole on the bowl cover. Move the Speed selector from "OFF" 8. Is complete, turn the Speed selector And a speed is selected, a white LED Note: If the speed selector is already turned on before the appliance is plugged in, the speed selector LED Note: Always start on the slowest possible speed to avoid splashing Lights up around the speed selector. A work light will also light up over the working area. Light will flash off and on to let you Know the speed selector has been left Ingredients out of the bowl. Moved to "OFF", the working light will Attachment hub: The appliance comes with a built in multipurpose Adjusting the tool shaft: The appliance is adjusted at the Release the nut on the shaft of the tool. If the tool scrapes the bottom You can remove the Factory so that the attachment Of the bowl: Loosen the nut (A), Attachment cover (A) by pressing the Clears the bottom of the bowl. Screw shaft (B) downward into the Attachment hits the bottom of the Bowl or is too far away from the sides, To far away from the sides/bottom Of the bowl: Screw the shaft (B) See 3 for further instructions. Close to the bottom of the bowl as Switch the appliance off, remove the plug from the wall socket and Wait until the tools have stopped Never immerse the housing, plug, or cord in water or any other fluid. Wash all parts, except for the motor base, in warm soapy water. If using the dishwasher, place parts only on the top rack of your dishwasher. The housing should only be cleaned LT With a soft damp cloth, then dried with a cloth. Store the power cord in the cord Cord inwards into the hole on the rear PL The butter should be soft not hard. Stir the soft butter with sugar until creamy. While stirring, add the sour cream and vanilla sugar. Finally stir in the flour together with baking soda. [. . . ] Dough may be too wet, it sticks onto the side of Add more flour, 1 tablespoon at a time until the Process until dough cleans the The motor does not work. The appliance is not connected to the mains. Make sure to plug in the appliance before The appliance vibrates/ moves during operation. Make sure the rubber feet at the bottom of the unit are clean and dry. [. . . ]