User manual ELECTROLUX EWF 1029

[. . . ] The symbols you will see on some paragraphs of this booklet have the following meaning: The warning triangle and/or the key words (Warning!) emphasize information that is particularly important for your safety or correct functioning of the appliance. The information marked with this symbol provides additional instructions and practical tips on the use of the appliance. Tips and information about economical and ecological use of the machine are marked with this symbol. [. . . ] Rinse hold : by selecting this option the water of the last rinse is not emptied out to prevent the fabrics from creasing. When the programme has finished the phase light is on and the door is locked. Using the spin speed reduction button you can choose the desired spin. After having selected the required programme, press this button to start the machine; the corresponding pilot light stops flashing and remains lit. To interrupt a programme which is running, depress the Start/Pause button: the corresponding pilot light starts to flash. To restart the programme from the point at which it was interrupted, press the START/PAUSE button again. When you select the programme, the lights relevant to the phases that form the programme light up. After the machine has started, only the running phase pilot light stays on. / : when this light comes on this means that the machine is performing the washing phase. If you have selected the "Prewash" function, this light will be on during the prewash phase too. The selector dial can be turned either clockwise or anticlockwise. At the end of the programme the selector dial must be turned to position O, to switch the machine off. If you turn the programme selector dial to another programme when the machine is working, the lights of the programme progress display start to flash. The machine will not perform the new selected programme. The pilot light also flashes in the event of operating problems: - 4 flashes = the door has not been closed - 2 flashes = the machine does not empty - 1 flash = the machine does not fill To eliminate the problem, see paragraph "Something not working". Follow the wash code symbols on each garment label and the manufacturer's washing instructions. The following weights are indicative: bathrobe napkin quilt cover sheet pillow case tablecloth towelling towel tea cloth night dress ladies' briefs man's work shirt man's shirt man's pyjamas blouse men's underpants 1200 g 100 g 700 g 500 g 200 g 250 g 200 g 100 g 200 g 100 g 600 g 200 g 500 g 100 g 100 g Whites may lose their "whiteness" in the wash. New coloured items may run in the first wash; they should therefore be washed separately the first time. Make sure that no metal objects are left in the laundry (e. Rub particularly soiled areas with a special detergent or detergent paste. It is therefore advisable to treat them prior to washing. Blood: treat fresh stains with cold water. [. . . ] The machine does not empty and/or does not spin: · Too much detergent or unsuitable detergent (creates too much foam) has been used. ⷠCheck whether there are any leaks from one of the inlet hose fittings. It is not always easy to see this as the water runs down the hose; check to see if it is damp. The cap on the emergency emptying hose has not been replaced after cleaning the pump. [. . . ]