User manual ELECTROLUX ULTRAONE ZUOANIMAL

[. . . ] Cleaning and maintenance shall not be made by children without supervision. Always disconnect the plug from the mains before cleaning or maintaining the appliance. Never use the vacuum cleaner without its filters. Caution This appliance contains electrical connections: • Never use the vacuum cleaner without dust bag in place • Never vacuum any liquid • Do not immerse in any liquid for cleaning • The hose should be checked regularly and must not be used if damaged. [. . . ] Open the cover by pushing the release button. Insert the hose (to remove it, press the lock buttons and pull the hose out). Attach the telescopic tube to the floor nozzle (to remove it, press the lock button and pull the nozzle off ). Attach the telescopic tube to the hose handle (to remove it, press the lock button and pull the hose handle out). Adjust the telescopic tube by holding the lock with one hand and pulling the handle with the other hand. Pull out the power cord and plug it into the mains. A zero ”0” will be visible in the display on the body. The model can be operated by the ON/OFF button on the handle. Battery indicator blinks red when battery level is low. The cleaner starts in autofunction (automatic suction power regulation). After vacuuming rewind the cable by pushing the rewind button. Unscrew the wheel axis and clean all parts. Change battery when light indicator is blinking red or when it is not responding when pressing any button. Batteries must be removed from the appliance before it is scrapped and are to be disposed of safely. The vacuum cleaner does not start • Check that the cable is connected to the mains. € Check that the plug and cable are not damaged. € Check if the battery indicator shows red, or does not respond, replace the battery in both cases. The dust bag indicator light is illuminated • Check if the dust bag is full or blocked. € If you have already changed the dust bag, change the motor filter. Eng The filter indicator light is illuminated • Change the Hepa filter. All lights are blinking The cleaner might be overheated: disconnect it from the mains; check if the nozzle, tube or hose are blocked. Let the cleaner cool down for 30 minutes before plugging it in again. [. . . ] Note: The warranty does not cover any damage to hoses caused by cleaning them. Water has entered the vacuum cleaner It will be necessary to replace the motor at an authorized Electrolux service centre. Damage to the motor caused by the penetration of water is not covered by the warranty. For any further problems, contact an authorized Electrolux service centre. [. . . ]