User manual ELECTROLUX Z2306

[. . . ] The above can cause serious damage to the motor - damage which is not covered by the warranty. Electrical cable precautions: · A damaged cable must be replaced by an authorised Electrolux service engineer. Damage to the cleaner cable will not be covered by the warranty. · Never pull or lift the vacuum cleaner by the cable. [. . . ] 2 It is sometimes possible to clear the hose by "massaging" it. However, be careful in case the obstruction has been caused by glass or needles caught inside the hose. Note: The warranty does not cover any damage to hoses caused by cleaning them. Cleaning the floor nozzle 3 To avoid reduction in suction power, frequently clean the dual purpose floor nozzle. The easiest way to clean it is by using the hose handle. 2 1 3 6 TROUBLESHOOTING AND CUSTOMER INFORMATION Troubleshooting The vacuum cleaner does not start 1 Check that the cable is connected to the mains. 2 Check that the plug and the cable are not damaged. The vacuum cleaner stops 1 Check whether the dustbag is full. Water has entered the vacuum cleaner It will be necessary to replace the motor by an authorised Electrolux service engineer. Damage to the motor caused by the penetration of water is not covered by the warranty. Customer Information Electrolux decline all responsibility for all damages arising from any improper use of the appliance or in cases of tampering with the appliance. This product is designed with the environment in mind. All plastic parts are marked for recycling purposes. For futher details see our website: www. electrolux. com For repairs or accessories, contact the Electrolux Group Floorcare Helpline on 08706 055 055. If you have any comments on the cleaner or the Instructions for Use booklet please e-mail us at: floorcare@electrolux. com 7 ELECTRICAL SUPPLY INSTRUCTIONS Before you start . . . check the voltage Before connecting the cleaner to an electrical supply ensure that voltage marked on the data plate (on the underside of cleaner) is correct for your electrical supply. If is not, do not use the cleaner but refer back to your dealer. Connecting to your electrical supply Permanently connected to the cleaner is a mains supply (2-core) cable fitted with a non-rewirable plug incorporating a 13A fuse. In the event of the fuse requiring replacement the fuse cover should be removed using a small screwdriver. The old fuse MUST be replaced by a 13A ASTA approved BS1362 fuse and the fuse cover mustbe replaced before the plus is used again. In the event ofloss of the fuse cover, replacements can be obtained from your Electrolux dealer or Electricity Board and must be of the same colour as indicated by the coloured insert on the base plug. If difficulty is experienced in obtaining a replacement, contact your nearest Electrolux Service Centre. (Please see the separate Electrolux Service Organisation leaflet). In no circumstances must be plug be used without a correct fuse cover fitted If the plug that is fitted to your appliance is not suitable for your socket outlet, it must be cut off and the appropriate plug fitted. [. . . ] · Store your cleaner indoors in a cool, dry area. · Keep your work area well lighted. · Unplug electrical appliances before vacuuming them. SAVE THESE INSTRUCTIONS 9 GUARANTEE This guarantee is in addition to your statutory and other legal rights. Electrolux products are carefully designed, manufactured, tested and inspected and in consequence, we undertake to replace or repair any part found to be defective in material or workmanship, within one year of delivery to the original purchaser, free of charge. [. . . ]