User manual ELICA OM TOUCH SCREEN

[. . . ] 10 EN - Instruction on mounting and use Consult the designs in the front pages referenced in the text by alphabet letters. Closely follow the instructions set out in this manual. All responsibility, for any eventual inconveniences, damages or fires caused by not complying with the instructions in this manual, is declined. Note: the elements marked with the symbol “(*)” are optional accessories supplied only with some models or elements to purchase, not supplied. [. . . ] Cover that surface with a protective covering and place all canopy hood parts and hardware in it. € In addition check whether near the installation area of the hood (in the area accessible also with the hood mounted) an electric socket is available and it is possible to connect a fumes discharge device to the outside (only suction version). € Carry out all the masonry work necessary (e. Installation of an electric socket and/or a hole for the passage of the discharge tube). Expansion wall plugs are provided to secure the hood to most types of walls/ceilings. However, a qualified technician must verify suitability of the materials in accordance with the type of wall/ceiling. The wall/ceiling must be strong enough to take the weight of the hood. Do not tile, grout or silicone this appliance to the wall. Only for some models An aesthetic flue can be purchased as an optional accessory. Check with the authorized dealer whether the model in your possession envisages this possibility. We advise installing the hood after having purchased the flue to check with certainty the most suitable installation. 5 • Apply three adhesive strips C to the back of the hood. If necessary (in the case of walls not perfectly perpendicular or in the presence of walls partly covered with tiles) apply two D spacers in correspondence with the definitive fixing holes (click fixing). € Trace a centre line on the wall to facilitate the montage (1), position the hole template so that the middle line printed on it corresponds to the centre line previously drawn and that the lower side of the grill corresponds to the lower part of the hood once mounted (2). € Make two holes with the 8 mm Ø drill and fix the support bracket with two dowels and wall screws (3). € Open the steam screen and remove the grease filter (see relative paragraph). € Hang up the hood (4), adjusting its position (5-6) and from the inner part of the hood mark two points for the definitive fixing (7). Remove the hood and make two 8 mm Ø holes (8), insert two wall dowels, hang the hood up again and fix it definitively with two screws (9). € Connect the electricity (10), but leave the hood disconnected from the general electric panel of the house. € If the hood is to be used in the suction version, install the flange supplied in the kit on the exit hole of the hood (11A - suction version – also install a fumes discharge tube of suitable dimensions) instead of the deflector (11F Mounting Before beginning installation: • Check that the product purchased is of a suitable size for the chosen installation area. € To facilitate installation, remove the fat filters and the other parts allowed and described here, dismantle and mount it. To remove see also the relative paragraphs. [. . . ] 4 Disconnect the hood from the electricity. Prior to touching the light bulbs ensure they are cooled down. 4 • Use a small screwdriver as a lever on the borders of the lamp in order to remove the lightbulb. € Slide out the lightbulb to be replaced and replace with a new 12V 20W MAX 30° Ø35 12V GU4. [. . . ]