User manual ELK PRODUCTS ELK-P412(K)

[. . . ] Power Supply APPLICATION ELK-P412 ELK-P412K Includes Battery 4 Amp, 12 Volt DC Power Supply & Battery Charger with Enclosure The ELK-P412 is a general purpose high current power supply and battery charger. It is ideal for alarm, access control, and CCTV applications requiring up to 4 Amps. [. . . ] Includes (1) Six foot AC Power Cord and cable clamp. Lifetime Limited Warranty, call for details. Automatic Low Battery Cutoff Circuit Protects Battery from Deep Discharge. 4 AMP POWER SUPPLY FILE E127738 POWER ON SW1 POWER OFF Before plugging in the power cord, replace the snap-on cover over the AC terminals for shock protection 14. 5VDC IN WARNIN G SHOCK HAZARD SPECIFICATIONS + · · · · · · · DC Output Voltage: 13. 8 Volts D. C. Auto Resetting "fuseless" circuit breakers (PTC). AC Input Voltage Range: 85~264VAC @ 47~63Hz. Enclosure Dimensions: 12. 5"H x 7. 5"W x 3. 75"D. Features and Specifications subject to change without notice. + POWER ON LEDS EARTH GROUND AC INPUT DC OUTPUT AC POWER ON LED NEG +12V OUTPUT 3 BATTERY LN LINE NEUTRL GRD -V +V NEG +12V OUTPUT 1 NEG +12V OUTPUT 2 DO NOT ADJUST (FACTORY SET) INSTALLATION / OPERATION 1. Set Master Power Switch (SW1) to Power Off. Mount enclosure in secure location near an AC power outlet that is not controlled by a switch. (supplied power cord is 6 feet long) 3. Connect devices to be powered to the screw terminals for DC output. The power distribution board has three sets of outputs, each set is limited to 2. 5 amps. If a device requires more that 2. 5 Amps, parallel two sets of terminals. Connect Battery to the battery wires, observe polarity. Warning High Voltage is now present at the power supply AC input terminals. Set the Master Power Switch to Power On. The LEDs at the power outputs should be on (if any are off, check for overloaded condition). [. . . ] If AC Power is lost then the relay will turn off closing the COM and N. C. The sounder is powered from the Battery. 4 AMP POWER SUPPLY WARNING SHOCK HAZARD ELK-967 POW ER DISTRIBUTION MODULE POWER ON 2. 5 AMP FUSE (PTC) 2. 5 AMP FUSE (PTC) 2. 5 AMP FUSE (PTC) SW1 POWER OFF 14. 5VDC IN + + OUTPUT 1 UP TO 2. 5 AMPS OUTPUT 2 UP TO 2. 5 AMPS OUTPUT 3 UP TO 2. 5 AMPS POWER ON LEDS EARTH GROUND AC INPUT DC OUTPUT AC POWER ON LED NEG +12V OUTPUT 3 BATTERY LN LINE NEUTRL GRD -V +V - + - + - + NEG +12V OUTPUT 1 NEG +12V OUTPUT 2 ELK-912 RELAY LOAD 1 LOAD 2 Voltage is lost here during AC Power Failure which will cause the relay to drop out and activate the sounder N COMNC O - + CONNECT LOADS TO EACH OUTPUT OR COMBINE OUTPUTS TO SUPPLY MORE CURRENT (DO NOT TO EXCEED 4 AMPS TOTAL) BLACK RED 12 Volt Battery 12 VOLT SOUNDER + [. . . ]