User manual EMERSON FANS 42 DAMP LOCATION

[. . . ] READ AND SAVE THESE INSTRUCTIONS ® SUMMER NIGHT® 42" Damp Location Ceiling Fan Owner's Manual Net Weight: Model No. CF742PFWW 00 CF742PFOB 00 10. 8 Lbs. LIMITED WARRANTY What The Warranty Covers: This warranty covers the motor and the other components and accessories of your Emerson ceiling fan against all defects in workmanship and materials. You must be the original purchaser or user of the product to be covered. What The Period Of Coverage Is: As it applies to the motor, this warranty will last for ten years from the date you purchased your ceiling fan. All other components and accessories are covered by this warranty for one year from the date you purchased your ceiling fan. [. . . ] Pass the 80" motor leads through the opening in the ceiling cover. Be sure the cover is oriented correctly. Separate, untwist and unkink the three motor leads. Route the motor leads through the hanger ball/downrod assembly. Remove the two setscrews from the motor coupling. Align the clevis pin holes in the downrod with the holes in the motor coupling. Install the clevis pin and secure with the hairpin clip (Figure 1). The clevis pin must go through the holes in the motor coupling and the holes in the downrod. Be sure to push the straight leg of the hairpin clip through the hole near the end of the clevis pin until the curved portion of the clip snaps around the clevis pin. Pull on the hanger ball to make sure the clevis pin is properly installed. ! WARNING It is critical that the clevis pin in the motor coupling is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed could result in the fan falling. 3 HANGER BALL/ DOWNROD ASSEMBLY CEILING COVER BLADE FLANGE SCREWS CLEVIS PIN SETSCREW CLEVIS PIN HAIRPIN CLIP SETSCREW BLADE ASSEMBLY Figure 1 MOTOR COUPLING Figure 3 NOTE: Take care not to scratch fan housing when installing blades. 9. You have now completed the assembly of your new ceiling fan. You can now proceed with hanging and the electrical wiring of your fan. 4. Reinstall the two setscrews in the motor coupling. While pulling up on the hanger ball, securely tighten the setscrews. NOTE: The setscrews must be properly installed as described above, or fan wobble could result. The fan comes with the blue, black, and white leads that are 80" long. Before installing fan, measure up approximately 6 to 9-inches above top of hanger ball/downrod assembly. Cut off excess leads and strip back insulation 1/2-inch from end of leads. Turn fan assembly upside down in preparation for mounting fan blade assemblies. IMPORTANT: THE SIDE OF THE FAN BLADE HAVING THE RIB LINE MUST BE FACING UPWARDS AS SHOWN IN FIGURE 2. 7. Mount blade flanges to fan blades using three 3/1624 x 1/2" screws per blade (Figure 2). Electrical Requirements Your new ceiling fan will require a grounded electrical supply line of 120 volts AC, 60 Hz, 15 amp circuit. [. . . ] Check main and branch circuit fuses or circuit breakers. Check line wire connections to fan and switch wire connections in switch housing. Check to make sure the screws which attach the fan blade flanges to the motor are tight. Check to make sure wire connectors in switch housing are not rattling against each other or against the interior wall of the switch housing. [. . . ]