User manual EMERSON FANS BUILDER

[. . . ] READ AND SAVE THESE INSTRUCTIONS Model No. CF700AW07 CF700WW07 CF700AB07 CF700PB07 CF700PBW07 Net Weight: CF700WPB07 CF700BS07 CF700WB07 CF700OB07 CF700CK07 13. 7 Lbs. ® BUILDER Series Ceiling Fan Owner's Manual Part No. BP7181-9 ! WARNING WARNING: To avoid fire, shock, and serious personal injury, follow these instructions. Safety Instructions 1. Read your owner's manual carefully and keep it for future reference. Before servicing or cleaning unit, switch power off at service panel and lock service panel disconnecting means to prevent power from being switched on accidentally. [. . . ] outlet box listed as "Acceptable for Fan Support". Install hanger bracket (item 1) to outlet box using the two screws supplied with the outlet box. Hanger bracket must seat firmly against outlet box. Remove wall board if necessary until bracket contacts box. ! WARNING WARNING Hanger bracket must seat firmly against outlet box. If the outlet box is recessed, remove wall board until bracket contacts box. If bracket and/or outlet box are not securely attached, the fan could wobble or fall. Run the downrod (item 3) through the ceiling cover (item 4). Run the three wires from the fan through the downrod. Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring. All wiring must be in accordance with National and Local codes and the ceiling fan must be properly grounded as a precaution against possible electrical shock. 3 7. Connect the green grounding lead from the hanger ball and the green grounding lead from the hanger bracket to the grounding conductor of supply (this may be a bare wire or wire with green colored insulation). Securely connect wires with wire connectors supplied. Securely connect the fan motor white wire to the supply white (neutral) wire using wire connector supplied. Securely connect the fan motor black wire and the blue wire to the supply black (hot) wire using wire connector supplied. After connections have been made, separate the white and green leads from the black and blue leads. Carefully turn the leads upward and push the green and white leads into one side of the outlet box. Then push the black and blue leads into the other side of the outlet box. Do not use abrasive cleaners which may cut through the protective lacquer and possibly damage the finish, use only a soft brush or lint free cloth to avoid scratching finish. Do not use water when cleaning you fan, as it could damage the motor or blades and create the possibility of an electrical shock. ! WARNING Do not use water when cleaning you fan, as it could damage the motor or blades and create the possibility of an electrical shock. WARNING Check to see that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire. Do not operate fan until blades are in place. Attach the ceiling cover (item 4) to the hanger bracket (item 1) using the two canopy setscrews. [. . . ] All other components and accessories are covered by this warranty for one year from the date you purchased your ceiling fan. ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, MADE WITH RESPECT TO COMPONENTS AND ACCESSORIES IS ALSO LIMITED TO ONE YEAR. What Will Emerson Company Do To Correct Problems: Emerson Company will replace a defective Emerson Air Comfort Ceiling Fan motor, blade, component or other accessory at no charge to you. If repair of the motor or blades is not practical or possible within a reasonable time and no replacement can be provided, Emerson will refund the actual purchase price of your fan. [. . . ]