User manual EMERSON FANS HIGH COUNTRY

[. . . ] Emerson High Country 3/10/05 9:32 AM Page 1 READ AND SAVE THESE INSTRUCTIONS Emerson Fans Designed by HIGH COUNTRY Ceiling Fan Owner's Manual Model Number KF160OI00 Ol d e Ir o n w i t h W a s h e d Oa k / H o n e y l r a Maple Blades Net Weight: 30. 6 Lbs. Part No. BP7283-1 Emerson High Country 3/10/05 9:32 AM Page 2 ! WARNING WARNING: To avoid fire, shock, and serious personal injury, follow these instructions. Safety Instructions 1. Read your owner's manual carefully and keep it for future reference. Before servicing or cleaning unit, switch power off at service panel and lock service panel disconnecting means to prevent power from being switched on accidentally. [. . . ] OUTLET BOX WARNING The outlet box and joist must be securely mounted and capable of supporting at least 50 lbs. outlet box listed as "Acceptable for Fan Support". ! WARNING HANGER BRACKET HANGER BALL/ DOWNROD ASSEMBLY To reduce the risk of fire, electric shock, or personal injury, mount fan to outlet box marked "Acceptable for Fan Support", and use screws supplied with outlet box. Most outlet boxes commonly used for support of light fixtures are not acceptable for fan support and may need to be replaced. Consult a qualified electrician if in doubt. 8 Figure 11 ! WARNING To avoid possible fire or shock, do not pinch wires between the hanger ball/downrod assembly and hanger bracket. Emerson High Country 3/10/05 9:32 AM Page 9 How to Wire Your Ceiling Fan If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician. ! WARNING Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity is turned off at the main fuse or circuit breaker box before wiring. All wiring must be in accordance with National and Local codes and the ceiling fan must be properly grounded as a precaution against possible electrical shock. CAUTION: To reduce the risk of electrical shock, disconnect the electrical supply circuit before installing the fan, light kit or receiver. Position the supply wires to the left side of the outlet box (Figure 12); position the fan wires to the right side. Partially insert the remote control receiver (flat side up) until one end rests on the hanger ball as shown in Figure 12. NOTE: Make all wiring connections using wire connectors (supplied). Make sure that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire. SUPPLY WHITE WIRE (NEUTRAL) 2. Refer to Figure 12 and 13 and connect the receiver wires to the supply wires and the fan motor wires as follows: a. Securely connect the green grounding wires from the hanger ball and the hanger bracket to the supply grounding conductor (this may be a bare wire or a wire with green insulation). Securely connect the supply white (neutral) wire to the receiver white (AC IN N) wire. Securely connect the supply black wire (hot) wire to the receiver black (AC IN L) wire. Securely connect the fan motor white wire to the receiver white (TO MOTOR N) wire. Securely connect the fan motor black wire to the receiver black (TO MOTOR L) wire. Securely connect the fan motor blue wire to the receiver blue (FOR BOTTOM LIGHT) wire. Securely connect the fan motor orange wire to the receiver orange (FOR UPPER LIGHT) wire. ! WARNING Check to see that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire. [. . . ] Do To Correct Problems: Emerson Electric Co. will replace a defective Emerson Air Comfort Ceiling Fan motor, blade, component or other accessory at no charge to you. If repair of the motor or blades is not practical or possible within a reasonable time and no replacement can be provided, Emerson Electric Co. will refund the actual purchase price of your fan. [. . . ]