User manual EMERSON FANS KITTY HAWK

[. . . ] READ AND SAVE THESE INSTRUCTIONS ® KITTY HAWKTM Ceiling Fan Owner's Manual Net Weight: Model No. 34. 5 Lbs. CF2800PW 00 CF2800BS 00 CF2800WB 00 LIMITED WARRANTY What The Warranty Covers: This warranty covers the motor and the other components and accessories of your Emerson ceiling fan against all defects in workmanship and materials. You must be the original purchaser or user of the product to be covered. What The Period Of Coverage Is: As it applies to the motor, this warranty will last for a lifetime of your ceiling fan. All other components and accessories are covered by this warranty for one year from the date you purchased your ceiling fan. [. . . ] Slightly separate the upper and lower fan blades and carefully seat the strut into the holes in the end of the fan blades (Figure 10). Secure the strut by installing two 6-32 x 6mm Phillips button head screws (supplied). Be careful not to scratch the blades. 6-32 x 6mm PHILLIPS BUTTON HEAD SCREWS (2) IMPORTANT: Perform steps 19 through 23 ONLY if you want to install your ceiling fan without the light fixture. If you want to install your fan with the light fixture, omit steps 19 through 23 and proceed to step 24. Remove the nut and lockwasher securing the light fixture to the switch housing cover (Figure 12). Unscrew the light fixture from the switch housing cover. Retain the light fixture in case you want to install it later. SWITCH HOUSING COVER REMOVE AND RETAIN THIS LOCKWASHER STRUT REMOVE AND RETAIN THIS NUT Figure 10 FAN BLADE 15. Grasp the blades and turn them over, then install the remaining four 6-32 x 6mm Phillips button head screws (supplied) to secure the struts. Remove the masking tape securing the two blade flanges together. Repeat steps 12 through 15 for the remaining four blade assemblies. Use the 10 round recessed holes in the motor hub marked with "5" and install the five blade assemblies in accordance with step 17. Attach one blade assembly to the motor hub using two 10-32 x 1" oval head screws (supplied) (Figure 11). Install four remaining blade assemblies in the same way. Gently snug all flange screws to the motor hub, working around the hub in a clockwise sequence. Next, securely tighten all flange screws, again working in a clockwise sequence. Failure to follow this procedure could result in fan wobble. This completes the blade installation. Figure 12 LIGHT FIXTURE 8-32 x 3/8" PAN HEAD SCREWS (2) 10-32 x 1" OVAL HEAD SCREW (2 per blade assembly) 20. Screw the 2-1/4" pipe nipple (supplied) several full turns into the switch housing cover (Figure 13). Reinstall and tighten the lockwasher and nut onto the nipple (Figure 13). Pass the speed control switch chain from the switch housing through the chain bushing in the switch housing cover (Figure 13). Attach the speed control pendant to the pull chain using a plastic coupler. Make sure all wires and wire connectors are inside the switch housing, then position the switch housing cover on the switch housing so that the two 8-32 x 3/8" pan head screws (previously installed) protrude through the keyhole slots in the switch housing cover. [. . . ] Check to make sure wire connectors in switch housing are not rattling against each other or against the interior wall of the switch housing. ! WARNING: Make sure main power is turned off. 4. Screws holding blades to flanges are loose. Setscrew in motor coupling is not tightened securely. Setscrew in the hanger ball/downrod assembly is loose. [. . . ]