User manual EMERSON FANS WESTFIELD

[. . . ] BP7305 Westfield 1/9/06 3:55 AM Page 1 READ AND SAVE THESE INSTRUCTIONS WESTFIELDTM Wet Location 52" Ceiling Fan Owner's Manual CF680BQ00 Net Weight: 24. 7 Lbs. Model No. CF680ORB00 LIMITED WARRANTY CF680WB00 What The Warranty Covers: This warranty covers the motor and the other components and accessories of your Emerson ceiling fan against all defects in workmanship and materials. You must be the original purchaser or user of the product to be covered. What The Period Of Coverage Is: As it applies to the motor, this warranty will last for ten years from the date you purchased your ceiling fan. All other components and accessories are covered by this warranty for one year from the date you purchased your ceiling fan. [. . . ] Unscrew the two upper setscrews (Figure 7) until they clear the inside of the motor coupling. Then separate, untwist and unkink the three 80" motor leads. Route the motor lead wires through the downrod. Align the clevis pin holes in the downrod with the holes in the motor coupling. Install the clevis pin and secure with the hairpin clip (Figure 7). The clevis pin must go through the holes in the motor coupling and the holes in the downrod. Be sure to push the straight leg of the hairpin clip through the hole near the end of the clevis pin until the curved portion of the hairpin clip snaps around the clevis pin. 15. Tighten the two upper setscrews (Figure 7) securely while pulling up on the downrod. NOTE: The setscrews must be properly installed as described above, or fan wobble could result. Install four 7-watt (maximum) candelabra bulbs (not supplied) in the sockets on top of the motor housing (Figure 7). Place the center glass on the rim of the fan motor and housing assembly; make sure the center glass is seated evenly in the housing flange (Figure 8). 7 BP7305 Westfield 1/9/06 3:55 AM Page 8 UPPER HOUSING ! WARNING It is critical that the pin in the hanger ball is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed could result in the fan falling. FAN MOTOR AND HOUSING ASSEMBLY CENTER GLASS Figure 8 18. Slide the upper housing over the downrod until it rests on the center glass (Figure 8). Make sure the upper housing is seated firmly on the rim of the center glass, then tighten the three setscrews in the upper housing collar (Figure 9). Make sure the grommet is properly installed in the upper housing cover, then slide the cover over the downrod until it rests on the upper housing (Figure 9). GROMMET UPPER HOUSING COVER SETSCREWS (3) UPPER HOUSING 20. Place the ceiling cover over the downrod. Then reinstall the hanger ball (Figure 10) on the downrod as follows. Route the three 80" motor leads through the hanger ball and slide the hanger ball over the downrod. Position the pin through the two holes in the downrod and align the hanger ball so the pin is captured in the groove in the top of the hanger ball. Pull the hanger ball up tight against the pin and securely tighten the setscrew in the hanger ball. A loose setscrew could create fan wobble. PIN HANGERBALL DOWNROD SETSCREW CEILING COVER Figure 10 COLLAR 21. The fan comes with blue, black and white leads that are 80" long. [. . . ] Check to make sure the screws which attach the blade flanges to the motor are tight. Check to make sure wire connectors in switch cup are not rattling against each other or against the interior wall of the switch cup. WARNING: Make sure main power is turned off. Screws securing fan blade flanges to motor are loose. [. . . ]