User manual EMERSON FANS WET LOCATION

[. . . ] READ AND SAVE THESE INSTRUCTIONS ® WET LOCATION 52" Ceiling Fan Owner's Manual Net Weight: Model No. CF653WW00 CF653OB00 20. 5 Lbs. LIMITED WARRANTY What The Warranty Covers: This warranty covers the motor and the other components and accessories of your Emerson ceiling fan against all defects in workmanship and materials. You must be the original purchaser or user of the product to be covered. What The Period Of Coverage Is: As it applies to the motor, this warranty will last for ten years from the date you purchased your ceiling fan. All other components and accessories are covered by this warranty for one year from the date you purchased your ceiling fan. [. . . ] One chain coupling NOTE: Place the parts from the loose parts bag in a small container to keep them from being lost. How to Put Your Ceiling Fan Together 1. Pass the 80" motor leads through the opening in the ceiling cover. Be sure the cover is oriented correctly. Separate, untwist and unkink the three motor leads. Route the motor leads through the hanger ball/downrod assembly. Loosen the setscrew in the motor coupling. Verify that the three rubber washers are installed and are flush against the shoulder on the downrod. Screw the downrod into the motor coupling as far as possible, aligning the hole in the downrod with the hole in the 3 motor coupling (Figure 1). Pass the screw with a rubber washer under the head through the motor coupling and downrod. Position a rubber washer on the screw and securely install the acorn nut. Securely tighten the setscrew in the motor coupling. ! WARNING It is critical that the clevis pin in the motor coupling is properly installed and the setscrews securely tightened. Failure to verify that the pin and setscrews are properly installed could result in the fan falling. SWITCH HOUSING DOWNROD SHOULDER RUBBER WASHERS (2) 1/4-20 x 7/16" BLADE FLANGE SCREWS (2) MOTOR HUB HANGER BALL/ DOWNROD ASSEMBLY CEILING COVER Figure 3 SCREW RUBBER WASHER SETSCREW RUBBER WASHER ACORN NUT MOTOR COUPLING 8. You have now completed the assembly of your new ceiling fan. You can now proceed with hanging and the electrical wiring of your fan. Figure 1 4. The fan comes with the blue, black, and white leads that are 80" long. Before installing fan, measure up approximately 6 to 9-inches above top of hanger ball/downrod assembly. Cut off excess leads and strip back insulation 1/2-inch from end of leads. Turn fan assembly upside down in preparation for mounting fan blade assemblies. IMPORTANT: THE SIDE OF THE FAN BLADE HAVING THE RIB LINE MUST BE FACING UPWARDS AS SHOWN IN FIGURE 2. Mount blade flanges to fan blades using three 3/16-24 x 5/16" screws per blade (Figure 2). Electrical Requirements Your new ceiling fan will require a grounded electrical supply line of 120 volts AC, 60 Hz, 15 amp circuit. The outlet box must be securely anchored and capable of withstanding a load of at least 50 pounds. ! WARNING To reduce the risk of fire, electric shock, or personal injury, mount fan to outlet box marked acceptable for fan support, and use screws supplied with outlet box. Most outlet boxes commonly used for support of light fixtures are not acceptable for fan support and may need to be replaced. [. . . ] Check main and branch circuit fuses or circuit breakers. Check line wire connections to fan and switch wire connections in switch housing. Check to make sure the screws which attach the fan blade flanges to the motor are tight. Check to make sure wire connectors in switch housing are not rattling against each other or against the interior wall of the switch housing. [. . . ]