User manual EMERSON HD1300WC0C

[. . . ] This warranty does not apply to damage from accident, misuse or alteration nor where the connected voltage is more than 5% above the nameplate voltage, nor to the equipment improperly installed or wired or maintained in violation of this Owner's Manual. No other written or oral warranty applies. No employee, agent, dealer or other person is authorized to give any warranties on behalf of Emerson Electric. The customer shall be responsible for all costs incurred in the removal or reinstallation and shipping of the product for repairs. [. . . ] Grasp bottle handle and hold the bottle upright over a sink. Press up on valve cap plunger for about one second to let out a little water. Look for leaks around "E-Z-Fill Side-Cap". If you hear air bubbles or see leaks, retighten "E-Z-Fill Side-Cap" and repeat steps 1-4. If either fill cap leaks, water may overflow and leak out of the rear vents of the cabinet. Position the water bottle back into the unit. Grasp the water bottle handle, and lower into the cabinet until the bottle sits on pads at bottom of cabinet. The "E-Z-Fill Side-Cap" must be facing the rear of the cabinet. When positioned properly, the plunger will open and water will flow into the cabinet. The water level will automatically remain at approximately 1/2" until the bottles are empty. 6 Rear of Humidifier "E-Z-Fill Side-Cap" Should Always Face Rear Turn Counterclockwise to Remove Cap Valve Cap Plunger Pivoting Lid Removed for Clarity HD1300 3 US manual 11/14/00 1:40 PM Page 7 Operating Humidifier Controls The operating controls of your Emerson evaporative humidifier are located on the top centre of the humidifier. To test the unit under this condition, turn Humidity Control all the way to MAX and unit should begin to operate. After the unit has been tested, set Humidity Control to medium or desired level. Allow 24 hours for humidifier to adjust. Humidity Rel. Step 5 If humidifier stops running and the Fill Light is not illuminated, the humidity level is at the normal requirements for that setting or it is adjusting to the home conditions. The table below shows recommended indoor humidity levels. The figure below shows approximate relative humidity percentages which correspond to the various settings of the Humidity Control. When Outdoor Recommended Indoor Temperature is: Relative Humidity is: -10°F 0°F 10°F 20°F & above Rel. Humidity 20% 25% 30% 35% If humidity level in home is sufficient, the humidifier will only operate with Humidity Control set on maximum. IMPORTANT: Water damage may result if condensation starts to form on windows or walls. Lift top cover off of the filter housing and set aside. Remove the two filters and dispose of properly. Clean internal parts of humidifier per the "Cleaning Your Humidifier" section of your owner's manual. Pivoting Lid Fan Assembly Spring Tabs Filter Housing 9 HD1300 3 US manual 11/14/00 1:40 PM Page 10 Replacement and Care of Filters (continued) c. Install new filters in the filter housing track with the glue beads of the wicking pad to the inside of the filter housing. [. . . ] Wet all surfaces normally exposed to water. Empty humidifier cabinet after 20 minutes. Rinse with water until bleach smell is gone. Water bottles should be cleaned in same manner. End of Season Maintenance 1. [. . . ]