User manual EMTEC EKCOH420

[. . . ] Batteries do not belong in children hands. Don’t let batteries lay around openly - they might be swallowed by children or animals. If this happens see a doctor immediately. Leaking or damaged batteries can upon contact with skin cause burning or acid damage - if necessary use suitable gloves. [. . . ] Enter the 4 digit code (12) from the Code Book. The LED (1) turns off after the last digit is entered. If you entered a wrong code the LED blinks for 3 seconds and then goes off. Point the remote in the direction of your TV and press the POWER button (3). Check other functions (for example for a VCR: FF or REW etc. If certain functions are not responding this indicates that the entered code is not the correct one. In that case repeat the above procedure with the next corresponding code of your brand. Repeat this procedure from step 1 for the other equipment you want to control (TV, VCR, DVD, SAT) 5) Manual code search If your equipment (TV, SAT etc. ) does not respond, try the other codes for your brand. if it still doesn’t respond , try the Code Search method. Note: As you can dedicate any appliance (TV, DVD, SAT. ) to the AUX keys you need first to enter any 4 digit code for the kind of appliance you wish to control (found in the code book), i. : If you want to program a SAT under the AUX key, enter any SAT code found in the code book and then follow the steps below: 1, Make sure your equipment is switched on. Press and hold S (2) until the LED indicator lights (1) steadily. Press the mode key (9) that matches the equipment you want to control (for example TV). If you step past the correct code use PROG - (6) to go back to the right code. When the equipment you want to control reacts press -/-- (13) to confirm the code. Note: If your equipment doesn’t have PROG +, you can use PLAY (VCR or DVD) (5) or POWER (3) key. The search starts after the last registered code. If that was 0030, the search starts at 0031 until the last possible code and then goes from 0000 to 0029. Note: if certain functions of your equipment can’t be controlled you have to find a different code for your brand. 6) Automatic code search When searching an unknown code, you can step through the library automatically (AutoSearch). [. . . ] If the remote loses codes within a few days/weeks the problem can be solved by using 2 new batteries from the same brand. If the LED is lit permanently, in general it will be necessary to replace the batteries. Important: The 2 in 1 Universal Remote Control must be used only in the way described in this instruction manual and may not be used for a purpose not intended. € Apăsaţi şi eliberaţi tasta Shift, după care apăsaţi tasta funcţională pe care o doriţi. [. . . ]