User manual ENCORE 802.11N WIRELESS PCI PCMCIA ADAPTER

[. . . ] Encore 802. 11n Wireless PCI / PCMCIA Adapter User's Guide FCC Certifications Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that If this equipment does cause interference will not occur in a particular installation. harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: -Reorient or relocate the receiving antenna. [. . . ] List information include Authentication Type, Encryption Type, Config Methods, Device Password ID, Selected Registrar, State, Version, AP Setup Locked, UUID-E and RF Bands. It is required to enter PIN Code into Registrar using PIN method. Each Network card has only one PIN Code of Enrollee. Display all of credentials got from the Registrar. List information includes SSID, MAC Address, Authentication and Encryption Type. If STA Enrollee, credentials are created as soon as each WPS success. If STA Registrar, RaUI creates a new credential with WPA2-PSK/AES/64Hex-Key and doesn't change until next switching to STA Registrar. Information about Security and Key in the credential. Command to connect to the selected network inside credentials. Command connect credentials to the next network inside Rescan Information PIN Code Config Mode Table of Credentials Detail Connect Rotate 24 Disconnect Stop WPS action and disconnect this active link. And then select the last profile at the Profile Page of RaUI if exist. If there is an empty profile page, the driver will select any non-secue AP Delete an existing credential. And then select the next credential if exist. If there is an empty credential, the driver will select any non-security AP. Start to add to Registrar using PIN configuration method Start to add to AP using PBC configuration method. Send the association request with WPS IE during WPS setup. Send the probe request with WPS IE during WPS setup. Display rate of progress from Start to Connected status Display currently WPS Status Delete PIN PBC WPS associate IE WPS probe IE Progress Bar Status Bar Note: When you click PIN or PBC, please don't do any rescan within two-minute connection. If you want to abort this setup within the interval, restart PIN/PBC or press Disconnect to stop WPS action. 25 Appendix Introduction to the configuration utility for Vista Users This utility helps Windows Vista users to configure the wireless network. Please refer to the following sections for introduction. Profile This profile page allows users to save different wireless settings, which helps users to get access to wireless networks at home, office or other wireless network environment quickly. 26 To add a new profile: 1. Note: you could also add a new profile quickly by selecting an available network in the "Site Survey" function then press the "Add to Profile" button. Fill in the information of this wireless network and its relative security settings. [. . . ] Apply: Apply the above changes. 35 Security Setting This page pops up after clicking the Security Settings button. Please follow the instructions below: Authentication Type Encryption Type WPA Pre-shared Key Select to be open or WPA-PSK system. Select an encryption type from the drop list. For WPA-PSK authentication mode, this field must be filled with character longer than 8 and less than 32 length. [. . . ]