User manual ENCORE ENNHD-1000

[. . . ] GIGA Network Disk Drive Enclosure ENNHD-1000 User's Guide FCC Certifications ENNHD-1000 has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. [. . . ] By Group: By User: Mark the checkbox to select an authorized group. Select an access-permission rule for this group and click "Save" to apply. Select an access authority for each user. Click "Save" to apply. Tips: To do an efficient access-authority configuration, please refer to the following recommend procedures: Step1. Select a Pre-defined authority level for all users. (Ex, Click "No Access for all users" to configure all users as "Non-access" for this folder. 39 Step2. Step4. Click "Current Access Permission for all users" to allow configuration by groups or users. Specify the users that have different authorities. (Ex, Click "Read & Write" for "Fion" and Click "Read-Only" for "Eric"). (Ex, Click "Save" to allow "Fion" to Read/Write this folder and "Eric" to read this folder. Other users are not allowed to access this folder. ) To Add a New Folder 1. Click the "Add" button on folder list. 2. Specify a folder name and description for the newly added folder. Note: Folder Name (0~15 characters): The name for the folder. Description (0~48 characters): A note for the folder. Both folder name and description are alphanumeric. Blank character is not allowed for folder name and description. 40 3. Setup the folder properties and click "Save" to apply. Note: For detail folder configuration, see "To configure folder properties" To Delete a Folder 1. Mark the check box of the folder that you are going to delete. Click Delete to delete the folder. 41 Disk- HD Configuration To format your hard disk in EXT3 format: 1. Mark the "Swap enable" check box or leave it blank. [. . . ] In the port-mapping session, the "Internal Host IP" should be configured as the IP address of this Device and the value of "Port" should be corresponded to the port number of the WEB server or FTP server you configured. (Ex, If the IP address of your device is 10. 10. 7. 251, the port number of your FTP is configured as 21 and the port for Web Server is as 8888, you should add or modify a port mapping record, set the Internal Host IP address as 10. 10. 7. 251, the Port as 21. then add or modify another port mapping record, set the Internal Host IP address as 10. 10. 7. 251 and the Port as 8888) 3. Before allowing the device to communicate with Internet, we strongly recommend users to add a Firewall device to secure your network from being invading. 70 5. [. . . ]