User manual ENCORE ENNHD-1GS

[. . . ] 3. 5" SATA HDD Network Storage Enclosure ENNHD-1GS User's Guide FCC Certifications This Equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. [. . . ] Configure the access-permission rules by groups and users: Note: Before starting, you have to click "Current Access Permission for all users" in the "Please set user's limit for this folder". By Group: By User: Mark the checkbox to select an authorized group. Select an access-permission rule for this group and click "Save" to apply. Select an access authority for each user. Click "Save" to apply. Tips: To do an efficient access-authority configuration, please refer to the following recommend procedures: Step1. Select a Pre-defined authority level for all users. (Ex, Click "No Access for all users" to configure all users as "Non-access" for this folder. Click "Current Access Permission for all users" to allow configuration 30 by groups or users. Specify the users that have different authorities. Click Save to apply. To Add a New Folder 1. Click the "Add" button on folder list. 2. Specify a folder name and description for the newly added folder. Note: Folder Name (0~15 characters): The name for the folder. Description (0~48 characters): A note for the folder. Both folder name and description are alphanumeric. Blank character is not allowed for folder name and description. 31 3. Setup the folder properties and click "Save" to apply. Note: For detail folder configuration, see "To configure folder properties" To Delete a Folder 1. Mark the check box of the folder that you are going to delete. Click Delete to delete the folder. Disk- HD Configuration To format your hard disk in EXT3 format: 1. Click "Yes" to execute HD Format. Start formatting after your confirmation. [. . . ] I have accessed the HD, but I can't access to the folders. Verify you have the correct username and password. If you have accessed to any folder in the HD and would like to use another set of username/ password for different authority, please log off your operation system and log on again. There are unrecognizable characters as the file name. [. . . ]