User manual ENCORE ENRXWI-SG

[. . . ] 108M 802. 11g Wireless LAN Access Point User Guide Regulatory notes and statements Wireless LAN, Health and Authorization for use Radio frequency electromagnetic energy is emitted from Wireless LAN devices. The energy levels of these emissions however are far much less than the electromagnetic energy emissions from wireless devices like for example mobile phones. Wireless LAN devices are safe for use frequency safety standards and recommendations. The use of Wireless LAN devices may be restricted in some situations or environments for example: ·On board of airplanes, or ·In an explosive environment, or ·In case the interference risk to other devices or services is perceived or identified as harmful In case the policy regarding the use of Wireless LAN devices in specific organizations or environments (e. g. [. . . ] Real panel 3 Ethernet Ethernet uplink port with auto-sensing for connecting to either 10/100Mbps Fast Ethernet connections, connect this port to switch/hub. Reset To reset the setting back to factory default setting, press the "Reset" button 3 seconds, once you press the button, the LED of the WLAN will turn off and when the Access Point is ready, the LED will start blinking. DC Power Connect the AC Power Adapter to the AP's power jack. Antenna There is one antenna in the rear panel, connect the antenna directly to the antenna screw in the rear panel. Hardware connections Notebo ok Sw itch/H ub PC Ethe rnet port Noteboo k Wireless LAN Netw orking Figure 3 4 Connect to the Switch/Hub 1. Plug in one end of the RJ45 network cable to the Switch/Hub port, 2. Plug in the other end of the RJ45 network cable to the Wireless Access Point. Check the installation The control LEDs of the Access Point are clearly visible and the status of the network link can be seen instantly: 1. Setup Wizard ­ Set Wireless LAN Connection Step 3: Set WEP Encryption If you like to enable WEP, please click "Enabled". Then, select the key size of WEP encryption and enter the key value in the key text box. Please click "Next" to continue. Figure 9. Setup Wizard ­ Set WEP Encryption 8 Step 4: Restart The Setup wizard is now completed. The new settings will be effective after the Access Point restarted. Please click "Restart" to reboot the Access Point. If you do not want to make any changes, please click "exit" to quit without any changes. You also can go back to modify the setting by clicking "Back". Figure 10. Setup Wizard ­ Restart Configuration through WEB Browser There are seven main functions included in the site contents: Wizard, Status, Basic Setting, IP Settings, Advanced Setting, Security and Tools. Point the selections in the top side of the menu screen. Figure 11. 9 Status The Status Function shows the System, Wireless Configuration and TCP/IP Configuration status and some settings of the Access Point. Figure 12. Status Firmware Version: Shows the current firmware version. LAN: Shows the Mac address, IP address (default: 192. 168. 1. 1), Subnet Mask, Gateway Address. The current LAN traffic calculated in terms of number of packets sent and received by AP through wired connection is also displayed. Wireless: Shows the Mac address, current ESSID, the status of Encryption Function (Enable or Disable), the current using channel. The current wireless traffic calculated in terms of number of packets sent and received by AP through wireless communication is also displayed. 10 View Log: Upon clicked, the page will change to log page. [. . . ] 11g mode only: User can use 11g only when he selects "enable". Super G mode: Super G mode is disabled by selecting "Disable" from the drop list. If you like to use Super G to enhance the speed, there are three options on Super G mode: Super G without turbo; Super G with Dynamic turbo and Super G with Static turbo. Turbo mode indicates the combination of two channels to enhance the throughput. [. . . ]