User manual ENERGY SPEAKER SYSTEMS V20-CM-SK

[. . . ] Reserve the scrim-cloth until the grille is painted and dry. If you are using a spray gun, set it for the most diffuse spray and try two very thin coats. If you are using a brush, thin the paint so that the grille holes will not be blocked. After the paint is dry, apply four or five small, thin spots of spray adhesive (similar to 3M Super 77) around the edge of the scrimcloth. [. . . ] Dolby, Dolby Digital EX, Dolby ProLogic are trademarks of Dolby Laboratories Licensing. DTSES, DTS are the trademarks of Digital Theater Systems Inc. Installation Considerations Energy Veritas packages the V2. 0-CM in three separate cartons. This makes it easier for installations in new construction, since only the necessary part is brought out to the job site at each stage of construction. In a retrofit to an existing wall, you must bring both an V2. 0-CM-SK speaker kit and an MKM-CM for EACH speaker location. Energy Veritas speakers and mounting kits are packed singly, not in pairs. However, the NCB-M-CM (New Construction Brackets) are bulk packed, four brackets in each carton. Optional - NCB-M-CM "Hole Saver" The NCB is never installed when fitting a speaker into an existing ceiling. It MAY be installed during a remodel or the construction of a new house, while the structural joists and studs are exposed. Typically, the wire is placed now, to avoid electrical wires (they can cause hum). The NCB is simply nailed between the studs and locked into position with screws. The intalled NCB forces the wallboard installer to cut the hole for the speaker, thus avoiding potential dust and mess. Additionally, it provides a tiedown to the speaker wire and clearly shows everyone where the speaker will be installed, avoiding misunderstandings. Required - API Mounting Kit MK-M-CM In new construction, the mounting kit is installed once the wall is covered with drywall or plaster. In a retrofit to an existing wall, the hole is cut and used to facilitate running wire back to the equipment location first, then the mounting kit is installed. Once the bezel is pushed into the hole, the spring loaded dogs are rotated into place. Now the bezel is ready for the speaker to be installed. For more detail, consult the instructions packed with the kit. Required - V2. 0-CM-SK In new construction, the V2. 0-CM speaker kit is only installed once the house is secure and ready for occupancy. In a retrofit, the speaker kit is installed after the bezel is mounted and before the grille is fitted. The NCB-M-CM "hole saving" bracket fits in between the joists, so there is no bulge in the drywall. / L'appui de nouvelle construction (NCB-M-CM) s'adapte entre les goujons, tellement là n'est aucun bombement dans le plaques de plâtre. Considérations d'Installation Energy Veritas empaquette le V2. 0-CM dans trois cartons séparés. Ceci le facilite pour des installations dans la nouvelle construction, puisque seulement la partie nécessaire est apportée dehors à l'emplacement du travail à chaque étape de construction. Dans une modification à un mur existant, vous devez apporter un kit de haut-parleur de V2. 0-CM-SK et un MK-M-CM pour CHAQUE endroit de haut-parleur. [. . . ] In the DIPOLE position the side drivers are active, but are wired out of phase from each other. The resulting sound field is even more expansive, and can create an even larger effect than the bi-pole mode. Orientez le tweeter vers l'auditeur. Ajustez la compensation de frontière par: Boundary Management Ajustez en plaçant le commutateur dans la position CORNER quand près d'un coin, la position WALL quand près d'une frontière simple de wall/ceiling et la position MID quand le haut-parleur est placé plus de 2 pieds de n'importe quelle frontière. [. . . ]