User manual ENGENIUS FREESTYL 1

[. . . ] Caution: Your wireless telephone gives you freedom and flexibility to stay in touch while you move around. However, when using your phone equipment, safety instructions should be followed to avoid the risks of fire, electric shock, injury to person, and damage to property. When using your wireless phone, ensure your safety and the safety of others: a. Always watch where you are walking and standing. [. . . ] If the handset is not on the cradle, press any key (except SILENT soft key) to answer. When an incoming call arrives, the LCD will show the caller ID message, and the ringer will ring or vibrate unless the ringer has been turned off. Re: You can turn on the "Any Key Talk" from MENU-5-2 notes: 1. You can press SILENT (Left) soft key if you choose to ignore the call. Unlike turning off the ringer (from the handset menu), the SILENT key operation is valid only for the current call. If the LCD shows "Private" or "Unknown", the caller's information may have been blocked by the caller or the originating phone company. You can press the SILENT (Left) soft key if you choose to ignore the call. Unlike turning off the ringer the SILENT key operation is valid only for the current call. When an intercom call arrives (called from Base), the ringer will ring or vibrate unless the ringer has been to answer the intercom call. From Handset To end a telephone or intercom call, press Key, or place handset into From Base To end a telephone call, press key. When a call is in progress, it can be put on hold by key. Voice volume can only be adjusted during a call. The new setting remains effective for all future calls until changed. To return to the conversation, press UNHOLD (Left) soft key notes: 1. The call being placed on hold can be "un-hold" by the handset that puts it on hold. But if the handset press key to go back standby, then other handsets can press or to pick this held call (If press on base, it can also pick up this held call). Handset LCD displays a call is being on hold. An alert tone (double beep) every 30 seconds will remind the handset that a call is being on hold. , call transfer) after putting a call on-hold fails, the held call may be dropped. Voice volume can only be adjusted during a call. The new setting remains effective for all future calls until changed. After a link is established, you can press MUTE (Left) soft key to mute the handset microphone. [. . . ] However, this function depends on if there is "Line Reversal" signal sent out by PBX or PSTN, after the call hung up. Press "7" to Set Time to support DTMF Caller ID: (1) Use CHANGE (Left) soft key to select and confirm on or off. This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the bottom of this equipment is a label that contains, among other information, a product identifier in the format US: SNIW403BFS1. [. . . ]