User manual ENVISION G2016WA2

[. . . ] The changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Shielded interface cables and AC power cord, if any, must be used in order to comply with the emission limits. The manufacturer is not responsible for any radio or TV interference caused by unauthorized modification to this equipment. It is the responsibilities of the user to correct such interference. FCC Warning: To assure a continued FCC compliance, a user must use a grounded power supply cord and the provided shielded video interface cable with bonded ferrite cores. [. . . ] Install Remove Figure 1 2. Installing and Removing the Base 3. 4. 5. 6. Connect video cable (D-Sub cable) Make sure both monitor and computer are powered OFF. Connect the video cable ( D-Sub cable) to the computer, then to the monitor. Connect audio cable Connect one end of the audio cable to the back of the monitor and connect the other end to the computer's audio out port. Connect power cord Connect the power cord to a properly grounded AC outlet, then to the monitor Power-ON computer and monitor Power-ON the computer, then Power-ON the monitor Windows users: Setting the Timing Mode(Resolution and Refresh Rate) 2 Example: 1680X1050 @ 60 Hz Resolution Right-click on the Windows desktop > Properties > Settings > "Desktop Area". Refresh Rate (vertical frequency) See your graphic card's user guide for instructions. Example: English Deutsch Français Figure 2 Connecting Cables 1. 4. AC Power Cord DVI Cable Optional D-sub Cable Audio Cable 3 Front View of the Product Figure 3 1. Power Key Press the MENU button ( in fig. 3) to display the OSD menu on the screen. There are a total of 5 OSD submenus divided by categories. Select the desired submenu by pressing the OSD button < or > button (and in fig. 3); see section "OSD Menu Functions"). 3) to activate the selected function or associated submenu. If you selected submenu, now select the sub-function you want using the OSD buttons < or >( and in fig. Set the desired value using the OSD button < or >(and in fig. The current settings are automatically saved when you return to the previous level or exit the OSD menu. Repeat setups 2-5 to make further adjustments as needed. The OSD menu automatically disappears if no changes are made for more than 45 seconds (default setting). You can close it manually by pressing the AUTO (in fig. 3) button 4 Main Menu English Deutsch Français Figure 4 The OSD Message Adjusting the picture The descriptions for function control LEDS Main Main Menu Menu Item Icon Brightness/ Contrast Sub Menu Item Brightness Contrast Black level Auto level H-Position V-Position Clock Phase Audio Volume Mute Description Controls the picture's contrast, brightness, black level and auto level. Controls the picture's horizontal position. [. . . ] Adjust the Panel within 0 degree leaning forward and 20 degree leaning backward. You must bend harder to exceed 20 degree backward but this range is for packing the unit to a small size for storage only. Safety Tips If smoke, abnormal noise or odor came out from your monitor, caution you should remove the power cord immediately and call your service center. Never remove the rear cover of your monitor cabinet. The display unit inside contains high-voltage parts and may cause electric shock to human bodies. Never try to repair your monitor yourself. Always call your service center or a qualified technician to fix it. [. . . ]